FTOS Command Reference for the S-Series - Force10 Networks

line
Parameters
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Command
History
line c e s Enable and configure console and virtual terminal lines to the system.
Syntax line {aux 0 | console 0 | vty number [end-number]}
Parameters
Defaults Not configured
Command Modes CONFIGURATION
Command
History
interface Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For Loopback interfaces, enter the keyword loopback followed by a number
from zero (0) to 16383.
• For a Port Channel, enter the keyword port-channel followed by a number:
C-Series and S-Series: 1-128
E-Series: 1 to 32 for EtherScale, 1 to 255 for TeraScale
• For the SONET interfaces, enter the keyword sonet followed by slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN interface, enter the keyword vlan followed by a number from 1 to
4094.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
aux 0 Enter the keyword aux 0 to configure the auxiliary terminal connection.
Note: This option is supported on E-Series only.
console 0 Enter the keyword console 0 to configure the console port.
vty number Enter the keyword vty followed by a number from 0 to 9 to configure a virtual
terminal line for Telnet sessions.
The system supports 10 Telnet sessions.
end-number (OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line to
configure. You can configure multiple lines at one time.
Version 7.6.1.0 Introduced on S-Series
78 Control and Monitoring Commands