FTOS Command Reference for the S-Series - Force10 Networks

esequence prefix-list ipv4
c e s Re-assign sequence numbers to entries of an existing prefix list.
resequence prefix-list ipv4
Syntax resequence prefix-list ipv4 {prefix-list-name StartingSeqNum Step-to-increment}
Parameters
Defaults No default values or behavior
Command Modes EXEC
Command
History
Usage
Information
Related
Commands
EXEC privilege
When all sequence numbers have been exhausted, this feature permits re-assigning new
sequence number to entries of an existing prefix list.
seq c e s Assign a sequence number to a deny or permit filter in an IP access list while creating the
filter.
Syntax seq sequence-number {deny | permit} {source [mask] | any | host ip-address}}
[count [byte] | log ] [order] [monitor]
Parameters
prefix-list-name Enter the name of configured prefix list.
StartingSeqNum Enter the starting sequence number to resequence.
Range: 0 – 65535
Step-to-Increment Enter the step to increment the sequence number.
Range: 1 – 65535
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
Version 7.4.1.0 Introduced
resequence access-list Resequence an access-list
To delete a filter, use the no seq sequence-number command.
sequence-number Enter a number from 0 to 4294967290.
deny Enter the keyword deny to configure a filter to drop packets meeting
this condition.
permit Enter the keyword permit to configure a filter to forward packets
meeting this criteria.
FTOS Command Line Interface Reference, version 7.6.1.0 313