FTOS Command Reference for the S-Series - Force10 Networks

match tag
match tag
c e s Configure a filter to redistribute only routes that match a specified tag value.
Syntax match tag tag-value
Parameters
To remove a match, use the no match tag command.
Defaults Not configured
Command Modes ROUTE-MAP
Command
History
Related
Commands
route-map
c e s Enable a route map statement and configure its action and sequence number. This command
also places you in the ROUTE-MAP mode.
Syntax route-map map-name [permit | deny] [sequence-number]
Parameters
tag-value Enter a value as the tag on which to match.
Range: zero (0) to 4294967295.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
match interface Redistribute routes that match the next-hop interface.
match ip address Redistribute routes that match an IP address.
match ip next-hop Redistribute routes that match the next-hop IP address.
match ip route-source Redistribute routes that match routes advertised by other routers.
match metric Redistribute routes that match a specific metric.
match route-type Redistribute routes that match a route type.
To delete a route map, use the no route-map map-name [permit | deny]
[sequence-number] command.
map-name Enter a text string to name the route map for easy identification.
permit (OPTIONAL) Enter the keyword permit to set the route map default as
permit.
If no keyword is specified, the default is permit.
376 Access Control Lists