Humminbird - Fish Finders and GPS

More documents

Recommendations

Info

Set Map Offset (Advanced) Set Map Offset allows you to change the map offset used by the 900 Series. NOTE: The Map Offset will be applied to all maps and not just the map that requires the correction. The Map Offset should be cleared if a different map is to be used. To change the Map Offset setting: 1. Activate the cursor and move it location where the Map Offset will be applied. Clear Map Offset (Advanced) Clear Map Offset allows you to clear the Map Offset. Clear Map Offset is only accessible if a Map Offset is currently active. To Clear Map Offset: 1. Make sure you are in Advanced User Mode, then highlight Clear Map Offset on the Navigation main menu. 2. Use the RIGHT 4-WAY Cursor Control key to clear the Map Offset. NOTE: The cursor must be active in order for this procedure to work. 2. Make sure you are in Advanced User Mode, then highlight Set Map Offset on the Navigation main menu. 3. Use the RIGHT 4-WAY Cursor Control key to set the Map Offset. A confirmation dialog box will appear to allow you to change your mind, or to confirm your choice. If the cursor was not active before you began this procedure, you will see an error message. Exit the menu, set the cursor, then try again. 103
Alarms Menu Tab From any view, press the MENU key twice to access the Main Menu System. The Alarms tab will be the default selection. NOTE: When an alarm is triggered, you can silence it by pressing any key. The alarm will be silenced, and will not be triggered again until a new instance of the alarm condition is detected. Depth Alarm Depth Alarm sounds when the depth becomes equal to or less than the menu setting. To change the Depth Alarm setting: 1. Highlight Depth Alarm on the Alarms main menu. 2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Depth Alarm setting. (OFF, 1 to 100 feet, or 0.5 to 30 meters [International models only], Default = OFF) Alarms Menu Fish ID Alarm Fish ID Alarm sounds when the 900 Series detects fish that correspond to the alarm setting. Fish ID Alarm will only sound if Fish ID+ is on. For example, if you've set the Fish ID Alarm to sound for Large fish only, the Fish ID alarm will sound when a large-sized fish is detected. Off All Large/Medium Large 104
Page 2 and 3:
Thank You! Thank you for choosing H
Page 4 and 5:
Table of Contents Views 38 Views an
Page 6 and 7:
Table of Contents 455 kHz Sensitivi
Page 8 and 9:
900 Series Introduction Your 900 Se
Page 10 and 11:
DualBeam PLUS Sonar Your 900 Series
Page 12 and 13:
The following GPS functionality is
Page 14 and 15:
Inside the boat there is often a ch
Page 16 and 17:
3 2 1 hole, then use it to mark the
Page 18 and 19:
1 Power 1 2 3 4 Plug Cable Connecto
Page 20 and 21:
Transducer Installation There are t
Page 22 and 23:
• The hydrodynamic shape of your
Page 24 and 25:
To mount the transducer pivot assem
Page 26 and 27:
5/8” Hole Escutcheon Plate Cable
Page 28 and 29:
GPS Receiver Installation To optimi
Page 30 and 31:
Access Under Mounting Location No A
Page 32 and 33:
Getting Started - Using Your 900 Se
Page 34 and 35:
Understanding Sonar History It is i
Page 36 and 37:
Understanding Side Imaging It is im
Page 38 and 39:
Side Imaging Technology: How it wor
Page 40 and 41:
Submerged Bridge: A Closer Perspect
Page 42 and 43:
To adjust the backlight or to adjus
Page 44 and 45:
INFO Key Press the INFO key while i
Page 46 and 47:
Views and Readouts All views have a
Page 48 and 49:
Sonar Zoom View Sonar Zoom View inc
Page 50 and 51:
Side/Sonar Combo View Side/Sonar Co
Page 52 and 53:
Screen Snapshot: When Screen Snapsh
Page 54 and 55:
Playing back a recording: Highlight
Page 56 and 57:
Classic layout: The top portion of
Page 58 and 59:
Chart/Bird’s Eye Combo View Chart
Page 60 and 61: Chart View Chart View shows cartogr
Page 62 and 63: Chart/Side Combo View Chart/Side Co
Page 64 and 65: NOTE: The built-in UniMap does not
Page 66 and 67: Save, Edit, or Delete a Waypoint Sa
Page 68 and 69: Add or Remove a Trolling Grid: From
Page 70 and 71: Man Overboard (MOB) Navigation As s
Page 72 and 73: Start-Up Options Menu Press the MEN
Page 74 and 75: Self Test Self Test displays result
Page 76 and 77: Sonar X-Press Menu The Sonar X-Pres
Page 78 and 79: Upper Range (Advanced: Sonar, Split
Page 80 and 81: Bottom Lock (Sonar Zoom View only)
Page 82 and 83: SI Side SI Side sets which transduc
Page 84 and 85: Active Side Active Side allows you
Page 86 and 87: Save Current Route (Only when navig
Page 88 and 89: Delete allows you to delete a waypo
Page 90 and 91: Delete All Images (optional-purchas
Page 92 and 93: Stop Playback (optional-purchase MM
Page 94 and 95: Fish ID+ Fish ID+ uses advanced sig
Page 96 and 97: Bottom View Bottom View selects the
Page 98 and 99: Surface Clutter (Advanced) Surface
Page 100 and 101: Transducer Select Transducer Select
Page 102 and 103: Saved Tracks Saved Tracks allows yo
Page 104 and 105: North Reference North Reference all
Page 106 and 107: Course Projection Line Course Proje
Page 108 and 109: Map Borders Map Borders allows you
Page 112 and 113: To change the Fish ID Alarm setting
Page 114 and 115: Arrival Alarm Arrival Alarm sounds
Page 116 and 117: Units - Depth To change the Units -
Page 118 and 119: Select Readouts Select Readouts (Ad
Page 120 and 121: Aux Temp Offset (Advanced) Aux Temp
Page 122 and 123: Digits Format (Advanced) Digits For
Page 124 and 125: The following views are available:
Page 126 and 127: To turn Screen Snapshot on or off:
Page 128 and 129: Display Problems There are several
Page 130 and 131: 1-Year Limited Warranty We warrant
Page 132 and 133: 900 Series Accessories Accessories
Page 134 and 135: Specifications Depth Capability . .
Page 136 and 137: Glossary Display, FSTN: FSTN is an
Page 138 and 139: Glossary QuadraBeam PLUS: QuadraBea
Page 140 and 141: Glossary Transducer: The transducer
Page 142 and 143: Glossary Cold Start: Cold Start ref
Page 144 and 145: Glossary Speed Over Ground (SOG): S
Page 146: Contact Humminbird® Contact the Hu
show all

Humminbird - Fish Finders and GPS

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?