Humminbird - Fish Finders and GPS
Humminbird - Fish Finders and GPS
Humminbird - Fish Finders and GPS
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
3. Use electrical tape to secure the NMEA pigtail to the cable as<br />
shown.<br />
NOTE: Leave the NMEA pigtail secured to the cable unless needed. This will<br />
make removing the receiver easier.<br />
4. Route the <strong>GPS</strong> receiver cable through the stem <strong>and</strong> continue with<br />
the planned route you chose in step 1.<br />
5. Attach the <strong>GPS</strong> receiver to its base using the included #6 - 7/8"<br />
screws.<br />
Access Under Mounting Location<br />
Follow these steps to deck mount the <strong>GPS</strong> receiver when routing the cable<br />
down through the mounting location:<br />
1. Determine the best location, then test route the 20' (6 m) cable from<br />
the mounting location to the control head.<br />
NOTE: Installation details may vary with unit configuration.<br />
2. Mark the mounting location <strong>and</strong> drill a 3/4" (19 mm) hole for the<br />
cable <strong>and</strong> cable plug. Route the cable.<br />
1<br />
3<br />
3. Cover the cable hole with the receiver. Make sure the receiver is<br />
flush on the surface <strong>and</strong> mark the two mounting holes with a pencil<br />
or punch.<br />
4. Move the receiver to the side <strong>and</strong> drill two pilot holes using a 9/64"<br />
(3.5 mm) bit.<br />
NOTE: Remember to caulk or seal screw holes <strong>and</strong> drilled holes as needed to<br />
protect your boat from water damage.<br />
2<br />
4<br />
5. Align the <strong>GPS</strong> receiver screw holes over the pilot screw holes <strong>and</strong><br />
attach with the #8 - 1 1/4" Phillips head screws. H<strong>and</strong> tighten only!<br />
NOTE: If the mounting surface is thin <strong>and</strong> made of a lighter material, a backing<br />
material may be needed below the mounting surface.<br />
1<br />
2<br />
NMEA Pigtail Taped<br />
NMEA Pigtail Cable Out<br />
3<br />
4<br />
Mounting Screws<br />
Cable Route<br />
22