Humminbird - Fish Finders and GPS

More documents

Recommendations

Info

SI Side SI Side sets which transducer beam from the SI beams will be shown on the display. To Adjust SI Side: 1. Highlight SI Side on the Side Imaging X-Press Menu. 2. Use the RIGHT 4-WAY Cursor Control key to select the transducer beam (Left, Both, Right, Default = Both) SI Sensitivity SI Sensitivity controls how much detail is shown on the display. Increasing the sensitivity shows more sonar returns from small baitfish and suspended debris in the water; however, the display may become too cluttered. When operating in very clear water or greater depths, increased sensitivity shows weaker returns that may be of interest. Decreasing the sensitivity eliminates the clutter from the display that is sometimes present in murky or muddy water. If SI Sensitivity is adjusted too low, the display may not show many sonar returns that could be fish. To adjust the SI Sensitivity: 1. Highlight SI Sensitivity on the Side Imaging X-Press menu. 2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to increase or decrease the SI Sensitivity setting. (Auto, 1 to 20, where Low = 1, High = 20, Default = 10) SI Range SI Range sets the deepest range that will displayed in the Side Imaging views. The range must be set manually. The SI Range menu choice can only be accessed from the Side Imaging Views. To adjust the SI Range: 1. From any Side Imaging View, highlight SI Range on the Side Imaging X-Press Menu. 2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to increase or decrease the SI Range setting. (6 to 360 feet or 2 to 120 meters [International Models only], Default = 150 feet or 50 meters) Chart Speed Chart Speed determines the speed at which the side sonar information moves down the display, and consequently the amount of detail shown. A faster speed shows more information in the Side Imaging Views and is preferred by most anglers; however, the sonar information moves across the display quickly. A slower speed keeps the information on the display longer, allowing you to see an entire area. Adjust Chart Speed to your personal preference. To adjust the Chart Speed: 1. Highlight Chart Speed on the Side Imaging X-Press Menu. 2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to increase or decrease the Chart Speed setting. (1-9, Ultra, where 1 = Slow, 9 = Fast, Ultra = Fastest, Default = 5) 75
SI Colors SI Colors allows you to select which color palette you would like to use for the display. To change the SI Colors: 1. Highlight SI Colors on the Side Imaging X-Pressmenu. 2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the color palette. (Inverse, Gray, Brown, Blue, Green, Default = Blue) Navigation X-Press Menu The Navigation X-Press Menu provides access to the settings most frequently used. Press the MENU key once while in the Bird's Eye View, the Chart or the Chart/Sonar Combo, Chart/Chart Combo View, or Chart/Bird’s Eye Combo View to access the Navigation X-Press Menu. NOTE: Menu choices will vary depending on system settings, such as whether you are currently navigating. NOTE: You will have to change Active Side setting to Right to see the Navigation X-Press Menu from a Combo View with a sonar side. Navigation X-Press Menu 76
Page 2 and 3:
Thank You! Thank you for choosing H
Page 4 and 5:
Table of Contents Views 38 Views an
Page 6 and 7:
Table of Contents 455 kHz Sensitivi
Page 8 and 9:
900 Series Introduction Your 900 Se
Page 10 and 11:
DualBeam PLUS Sonar Your 900 Series
Page 12 and 13:
The following GPS functionality is
Page 14 and 15:
Inside the boat there is often a ch
Page 16 and 17:
3 2 1 hole, then use it to mark the
Page 18 and 19:
1 Power 1 2 3 4 Plug Cable Connecto
Page 20 and 21:
Transducer Installation There are t
Page 22 and 23:
• The hydrodynamic shape of your
Page 24 and 25:
To mount the transducer pivot assem
Page 26 and 27:
5/8” Hole Escutcheon Plate Cable
Page 28 and 29:
GPS Receiver Installation To optimi
Page 30 and 31:
Access Under Mounting Location No A
Page 32 and 33: Getting Started - Using Your 900 Se
Page 34 and 35: Understanding Sonar History It is i
Page 36 and 37: Understanding Side Imaging It is im
Page 38 and 39: Side Imaging Technology: How it wor
Page 40 and 41: Submerged Bridge: A Closer Perspect
Page 42 and 43: To adjust the backlight or to adjus
Page 44 and 45: INFO Key Press the INFO key while i
Page 46 and 47: Views and Readouts All views have a
Page 48 and 49: Sonar Zoom View Sonar Zoom View inc
Page 50 and 51: Side/Sonar Combo View Side/Sonar Co
Page 52 and 53: Screen Snapshot: When Screen Snapsh
Page 54 and 55: Playing back a recording: Highlight
Page 56 and 57: Classic layout: The top portion of
Page 58 and 59: Chart/Bird’s Eye Combo View Chart
Page 60 and 61: Chart View Chart View shows cartogr
Page 62 and 63: Chart/Side Combo View Chart/Side Co
Page 64 and 65: NOTE: The built-in UniMap does not
Page 66 and 67: Save, Edit, or Delete a Waypoint Sa
Page 68 and 69: Add or Remove a Trolling Grid: From
Page 70 and 71: Man Overboard (MOB) Navigation As s
Page 72 and 73: Start-Up Options Menu Press the MEN
Page 74 and 75: Self Test Self Test displays result
Page 76 and 77: Sonar X-Press Menu The Sonar X-Pres
Page 78 and 79: Upper Range (Advanced: Sonar, Split
Page 80 and 81: Bottom Lock (Sonar Zoom View only)
Page 84 and 85: Active Side Active Side allows you
Page 86 and 87: Save Current Route (Only when navig
Page 88 and 89: Delete allows you to delete a waypo
Page 90 and 91: Delete All Images (optional-purchas
Page 92 and 93: Stop Playback (optional-purchase MM
Page 94 and 95: Fish ID+ Fish ID+ uses advanced sig
Page 96 and 97: Bottom View Bottom View selects the
Page 98 and 99: Surface Clutter (Advanced) Surface
Page 100 and 101: Transducer Select Transducer Select
Page 102 and 103: Saved Tracks Saved Tracks allows yo
Page 104 and 105: North Reference North Reference all
Page 106 and 107: Course Projection Line Course Proje
Page 108 and 109: Map Borders Map Borders allows you
Page 110 and 111: Set Map Offset (Advanced) Set Map O
Page 112 and 113: To change the Fish ID Alarm setting
Page 114 and 115: Arrival Alarm Arrival Alarm sounds
Page 116 and 117: Units - Depth To change the Units -
Page 118 and 119: Select Readouts Select Readouts (Ad
Page 120 and 121: Aux Temp Offset (Advanced) Aux Temp
Page 122 and 123: Digits Format (Advanced) Digits For
Page 124 and 125: The following views are available:
Page 126 and 127: To turn Screen Snapshot on or off:
Page 128 and 129: Display Problems There are several
Page 130 and 131: 1-Year Limited Warranty We warrant
Page 132 and 133:
900 Series Accessories Accessories
Page 134 and 135:
Specifications Depth Capability . .
Page 136 and 137:
Glossary Display, FSTN: FSTN is an
Page 138 and 139:
Glossary QuadraBeam PLUS: QuadraBea
Page 140 and 141:
Glossary Transducer: The transducer
Page 142 and 143:
Glossary Cold Start: Cold Start ref
Page 144 and 145:
Glossary Speed Over Ground (SOG): S
Page 146:
Contact Humminbird® Contact the Hu
show all

Humminbird - Fish Finders and GPS

Create successful ePaper yourself

Delete template?

Save as template?