STX Signal Transmitter Installation and Operation ... - Kistler-Morse

Chapter 6. MVS-STX Inputs and Outputs Menu
11. The display looks like this:
Addr XX CHAN# YY
420mA*
020mA
F1 F2 F3
(Asterisk indicates the current selection.)
12. Press the F1 Key for the current output
range to be 4 to 20 mA or the F3 Key for
0 to 20 mA. The display acknowledges
the selection and returns to:
CURRENT OUTPUT
Set Mode Rprt
F1 F2 F3
13. Press the F1 Key to access the Set
Menu. If you added one output, proceed
to Step 14. If you added two outputs, the
display looks like this:
SELECT OUTPUT
X/20#1
Y/20#2
F1 F2 F3
A ‘4’ or ‘0’ will be in place of the ‘X’ and
‘Y.’ Press the F1 Key to set up output #1
or the F3 Key to set up output #2.
14. The display looks like this:
SET:
XmA
A ‘4’ or a ‘0’ will be in place of the ‘X.’
15. Press the F1 Key to access 4/0mA. The
display looks like this:
X/20#Y LO VALUE
A ‘4’ or a ‘0’ will be in place of the ‘X.’
(Units are consistent with Units Menu.)
16. Use the keypad or Arrow Keys to input a
value for the weight where you want the
current transmitter to output 4 mA (0 mA
if applicable). Press the Enter Key.
The display acknowledges the entry and
returns to:
SET:
XmA
20mA
F1 F2 F3
> 0 lbs
F1 F2 F3
20mA
F1 F2 F3
17. Press the F3 Key to access 20mA. The
display looks like this:
X/20#Y HI VALUE
18. Use the keypad or Arrow Keys to input a
value for the weight where you want the
current transmitter to output 20 mA.
Press the Enter Key. The display acknowledges
the entry and returns to:
SET:
XmA
F1 F2 F3
19. Press the Menu Key to access the
menu’s second page. The display shows:
SET:
Net/Grs
22. Press the F3 Key to select Fsafe. The
display shows:
FAIL-SAFE MODE?
Lo* Hi NC
F1 F2 F3
(Asterisk indicates the current selection.)
23. Press the F1, F2, or F3 Key to select the
desired fail-safe condition. The display
acknowledges the selection and
returns to:
SET:
Net/Grs
FSafe
F1 F2 F3
20. Press the F1 Key to access Net/Grs.
The display shows:
SELECT OPERATION
Net
*Gross
F1 F2 F3
(Asterisk indicates the current selection.)
21. Press the F1 Key to select Net or the F3
Key to select Gross. The display acknowledges
the selection and returns to:
SET:
Net/Grs
20mA
FSafe
F1 F2 F3
FSafe
F1 F2 F3
24. Press the Esc Key to return to the
Current Output Menu and repeat Steps
10 through 23 to set up additional outputs
if desired.
25. Press the Esc Key to scroll up the menu
tree or press the Auto/Man Key to return
to channel monitoring.
> 9999 lbs
F1 F2 F3
A ‘4’ or a ‘0’ will be in place of the ‘X.’
(Units are consistent with Units Menu.)
6-8