Banner Faculty and Advisor Self-Service / User Guide / 8.4

12. Make sure that value-based security (VBS) has been setup and initiated.
13. If desired, modify the text associated with the SPACER label for the procedure
bwskotrn.P_ViewTran.
Set Up Degree Evaluation on the Web
Setup Requirements
Item
Term Control Form
(SOATERM)
Program Definition Rules
Form (SMAPRLE)
Curriculum Rules Form
(SOACURR)
Program Requirements
Form (SMAPROG)
WebCAPP Rules Form
(SMAWCRL)
CAPP Compliance Default
Parameter Form
(SMADFLT)
Description
Under Web Processing Controls/ WebCAPP Controls, the
Web Evaluation Term checkbox must be selected to permit
new degree evaluations to be generated for that term.
Note: This field may need to be updated each term,
depending upon your institution’s policy on running a
degree audit against a term in the past.
If the Web checkbox is selected, the program will be
available when a new degree evaluation is generated. This
will not prevent a student from viewing a previously
generated degree evaluation for this program.
Note: This indicator defaults to being selected.
For every program you want associated with the term, take
the following actions:
• Make sure that a record exists for the and that the Lock
checkbox is selected.
• On the Module Control window, select the On radio
button for Curriculum, Advising, and Program
Planning.
For every program that you want to be active, select the
Active radio button.
Select the appropriate checkboxes in the What-If Analysis
Display section to make concentrations and departments
available for what-if analysis on the Web.
Enter Web into the Default Code field. The appropriate
compliance request default parameters must be set up. For
more information about SMADFLT, see the CAPP
Handbook.
April 2010 Banner Faculty and Advisor Self-Service 8.4 7-72
User Guide
Student Information