M-Maxâ„¢ Series Adjustable Frequency Drive - Eaton Corporation
M-Maxâ„¢ Series Adjustable Frequency Drive - Eaton Corporation
M-Maxâ„¢ Series Adjustable Frequency Drive - Eaton Corporation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Parameters<br />
<strong>Drive</strong>s Control, continued<br />
Access<br />
Factory Setting<br />
PNU ID RUN Value/Range Description<br />
(P1.3)<br />
P6.15 184 — Keypad frequency reference (REF) 0.00<br />
–P6.4–P6.4 Hz The setpoint value (REF) defined here can be activated at<br />
parameter P6.2 and via the keypad (LOC/REM)<br />
In KEYPAD mode, the value can be changed with the arrow<br />
buttons. The changes are written back automatically to this<br />
parameter (P6.15)<br />
P6.16 1474 — Stop button active<br />
In the default settings, the STOP button of the keypad is<br />
active in all operating modes<br />
The Stop function can be set at parameter P6.8<br />
1<br />
0 No (deactivated)<br />
Stop executed only via control signal terminals (I/O) or<br />
fieldbus (BUS)<br />
Switching the LOC/REM button to KEYPAD removes the<br />
block on the STOP button function set here<br />
Note: This does not deactivate the Reset function (FS<br />
loading with 5s actuation of the STOP button)<br />
1 Yes (activated)<br />
P6.17 1427 X — Secondary remote control source<br />
Assignment of the control levels as at P6.1<br />
Control level 2 is activated via parameter P3.25<br />
3<br />
P6.18 1428 X — Secondary remote speed reference<br />
Assignment of setpoint sources as at P6.2<br />
Setpoint source 2 is activated via parameter P3.26<br />
2<br />
P6.19 502 — Secondary acceleration time (acc2) 10.0<br />
0.1–3000s See Note 1 of parameter P6.5<br />
The activation is executed via parameter P3.15<br />
P6.20 503 — Secondary deceleration time (dec2) 10.0<br />
0.1–3000s See Note 1 of parameter P6.6<br />
The activation is executed via parameter P3.15<br />
P6.21 526 X — Acceleration transition frequency (acc1–acc2) 0.00<br />
0.00–P6.4 Hz 0.00 Hz = deactivated<br />
If the output frequency set here is exceeded, the<br />
acceleration time is switched automatically from acc1 (P6.5)<br />
to acc2 (P6.19)<br />
P6.22 1334 X — Deceleration transition frequency (dec1–dec2) 0.00<br />
0.00–P6.4 Hz 0.00 Hz = deactivated<br />
If the output frequency set here is exceeded, the<br />
deceleration time is switched automatically from dec1 (P6.6)<br />
to dec2 (P6.20)<br />
P6.23 1429 X — REV blocked<br />
The rotating field reversal of the output frequency is blocked<br />
0<br />
0 Deactivated<br />
1 Activated<br />
84 M-Max <strong>Series</strong> <strong>Adjustable</strong> <strong>Frequency</strong> <strong>Drive</strong> MN04020003E—April 2011 www.eaton.com
Change language