M-Maxâ„¢ Series Adjustable Frequency Drive - Eaton Corporation

System Parameters
Access
FS
PNU ID RUN ro/rw Designation Value Range Page (P1.3)
Hard- and Software Information
S1.1 833 X ro API SW ID — 123 0
S1.2 834 X ro API SW version — 123 0
S1.3 835 X ro Power SW ID — 123 0
S1.4 836 X ro Power SW version — 123 0
S1.5 837 X ro Application ID — 123 0
S1.6 838 X ro Application revision — 123 0
S1.7 839 X ro System load % 123 0
Communication
S2.1 � 808 X ro Communication status In xx.yyy format
xx = Number of error messages
(0–64)
yyy = number of correct messages
(0–999)
123
S2.2 � 809 rw Fieldbus protocol 0 = FB disabled
1 = Modbus RTU
Note
� These parameters are overwritten with the bus-specific parameters when a fieldbus connection (for example, CANopen) is used.
The parameter values described in the manual of the fieldbus interface then apply.
123 0
S2.3 � 810 rw Slave address 1–255 123 1
S2.4 � 811 rw Baud rate 0 = 300
1 = 600
2 = 1200
3 = 2400
4 = 4800
5 = 9600
6 = 19200
7 = 38400
8 = 57600
123 5
S2.6 813 rw Parity type 0 = None, no, see 2 stop bits
1 = Even, see 1 stop bit
2 = Odd, see 1 stop bit
S2.7 814 rw Communication timeout 0 = Not used
1 = 1s
2 = 2s
…255 = up to 255s
S2.8 815 rw Reset communication status 0 = Not used
1 = Resets parameter S2.1
124 0
124 0
124 0
Appendix A
User
Setting
M-Max Series Adjustable Frequency Drive MN04020003E—April 2011 www.eaton.com 163