M-Maxâ„¢ Series Adjustable Frequency Drive - Eaton Corporation

Drives Control, continued
PNU ID
Access
RUN Value/Range Description
P6.10 717 X — REAF, Wait time before an automatic restart 0.50
0.10–10.00s Active, if P6.13 = 1
Waiting time until automatic restart, after the detected
error has disappeared
(REAF = Restart After Failure)
P6.11 718 X — REAF, Testing period over three automatic restarts 30.00
0.00–60.00s Active, if P6.13 = 1
Timed monitoring of the automatic restart
The monitoring time begins with the first automatic restart.
If more than three error messages occur during the testing
period, fault status is activated. Otherwise, the error is
acknowledged after the test time has elapsed and the test
time is only started again with the next error
P6.12 719 X — REAF, Start function with automatic restart 0
0 Ramp (acceleration)
1 Flying restart circuit
2 According to P6.7
P6.13 731 X — REAF, automatic restart after an error message 0
0 Deactivated
1 Activated
P6.14 1600 — Stop on direction change via the arrow buttons () of the 1
keypad (KEYPAD)
0 Deactivated, changes the direction of rotation (FWD
automatically on passing setpoint zero
REV)
1 Activated, stops the drive at setpoint zero and requires
another actuation of the Start button
Automatic Restart After Error Message
(Two Start Attempts)
START
TEST
FAULT
RESET
P6.10
P6.10 P6.10
P6.11
Item
Number Description
1 First automatic restart
2 Second automatic restart
3 Shut-off when error detected
4 Motor stop signal
TEST = monitored test tim
FAULT = shut-off when error message occurs
RESET = reset error message (FAULT)
Parameters
Factory Setting
(P1.3)
M-Max Series Adjustable Frequency Drive MN04020003E—April 2011 www.eaton.com 83