DIVISION 1 - GENERAL REQUIREMENTS - IDEAS-EC

2.7 SLEEVESA. Unless noted otherwise on the drawings, sleeves shall consist of galvanized steel schedule 40 pipe,two pipe sizes larger than the carrier pipe.2.8 OTHER EMBEDDED ITEMSA. Items encased in concrete shall not be painted.2.9 BONDING AGENTA. Construction joint bonding agent.1. Subject to compliance with requirements, use one of the following:a. “Day-Chem Ad Bond (J-40)” – Dayton Superiorb. “Superior Concrete Bonder (J-41)” – Dayton Superiorc. “EUCO Weld” – Euclid Chemical CompanyB. Epoxy bonding agent.1. Subject to compliance with requirements, use one of the following:a. "Sikadur 32" - Sika Chemical Co.b. “Sika Armatec 110" - Sika Chemical Co.c. "Resi-Bond" - Dayton Superiord. "Concresive LPL" - Master Builders2.10 CURING MATERIALSA. Curing compound or material shall be compatible with required finishes and/or coatings. Must mettthe requirements of ASTM C309 or ASTM C171.B. Sheet Materials: ASTM C171 and ASTM D 4397, 4-mil polyethylene film or waterproof paper.C. Spray Applied Membrane Forming Liquids (applied in accordance with ACI 301).1. Subject to compliance with ASTM C309 requirements, use one of the following:a. "Kure-N-Seal" - Sonnebornb. "Safe Cure & Seal (J-18)" - Dayton Superiorc. "Masterkure 200W" - Master Buildersd. “Eucocure VOX” – Euclid Chemical Co.D. Moisture cure surfaces where curing compound or material are incompatible with required finishesand/or coating.E. Water: Clean and not detrimental to concrete.2.11 ANCHORING SYSTEMSA. Anchor Bolts: ASTM F 1554 Grade 36, unless otherwise indicated.B. Adhesive Anchors: “HIT HY 150” Injection Adhesive Anchor – Hilti Fastening System or approvedequal.03300 - 704/07 CAST-IN-PLACE CONCRETE