DIVISION 1 - GENERAL REQUIREMENTS - IDEAS-EC

SECTION 09900PAINTINGPART 1 - GENERAL1.1 DESCRIPTIONA. The work in this section consists of painting and finishing work.B. Prime and finish coat new internal surfaces unless otherwise indicated on Drawings or inthis section of specification.C. Paint following elements unless otherwise indicated in this section or on Drawings:1. Steel pipe supports.2. Plain, insulated, or wrapped interior piping, valves, fittings, and appurtenances.3. Ferrous metals.D. Do not paint following elements:1. Stainless steel, or finish metal surfaces.2. Exposed to view aluminum surfaces including immersed surfaces except thosenoted previously.3. Fiberglass surfaces, unless indicated otherwise.4. Interior of pipe, ductwork, and conduits.5. Moving parts of mechanical and electrical units.6. Code labels and equipment identification and rating plates.7. Exterior concrete or precast concrete surfaces except as noted previously.8. Piping, ductwork or pipe conduit when enclosed between suspended ceiling andoverhead slabs, or located in pipe chases.9. Factory finished furniture, laboratory casework, metal toilet partitions, kitchenunits, lockers, mechanical equipment, electrical equipment, shop and storageequipment with an approved corrosion resistant finish, exterior louvers.10. Factory furnished motor control centers, control panels, engines, enginegenerators, outdoor electrical panels, electrical switchgear, and centrifuges.11. Threads on bolts, nuts, and threaded taps.12. Glazing.13. Plastic laminate surfaces.14. Copper flashing, gutters and downspouts.1.2 QUALITY STANDARDSA. Comply with applicable regulations of Occupational Safety and Health Act (OSHA) 28CFR 1926-1993B. Paint thickness specified is minimum dry mil thickness. Painting coverage rates in gallonper square foot quoted are based on manufacturer's published theoretical coverage data09900-111/07 PAINTING