DIVISION 1 - GENERAL REQUIREMENTS - IDEAS-EC

SECTION 15060PIPE AND PIPE FITTINGS: GENERAL STATEMENTPART 1 - GENERAL1.1 SECTION INCLUDESA. Utility piping systemsB. Pipe pressure testingC. Pipe cleaning and disinfection1.2 RELATED SECTIONSA. Section 15062 – Pipe: Ductile IronB. Section 15064 – Pipe: PVC PressureC. Section 15078 – Pipe: Polyethylene1.3 REFERENCESA. American National Standards Institute (ANSI)1. B16.3, Malleable Iron Threaded Fittings2. B16.5, Pipe Flanges and Flanged Fittings3. B31.1, Power Piping4. B31.3, Chemical Plant and Petroleum Refinery Piping5. B31.9, Building Services Piping6. B40.1, Gages - Pressure Indicating Dial Type - Elastic ElementB. American Society for Testing and Materials (ASTM)1. A53, Standard Specification for Pipe, Steel, Black and Hot-Dipped, Zinc-Coated Welded andSeamlessC. American Water Works Association (AWWA)1. C104, Cement-Mortar Lining for Ductile-Iron Pipe and Fittings for Water2. C110, Ductile Iron and Gray Iron Fittings, 3 IN through 48 IN for Water and Other Liquids3. C111, Rubber Gasket Joints for Ductile Iron and Gray Iron Pressure Pipe and Fitting4. C200, Steel Water Pipe 6 in and Larger5. C203, Coal Tar Protective Coatings and Linings for Steel Water Lines - Enamel and Tape -Hot Applied6. C205, Cement Mortar Lining and Coating for Steel Water Pipe 4 IN and Larger, ShopApplied7. C207, Steel Pipe Flanges for Waterworks Service - Sizes 4 IN through 144 IN8. C208, Dimensions for Fabricated Steel Water Pipe Fittings9. C210, Liquid Epoxy Coating Systems for the Interior and Exterior of Steel Water Pipelines10. C214, Tape Coating Systems for the Exterior of Steel Water Pipelines15060 - 104/08 PIPING AND PIPE FITTINGS: GENERAL STATEMENT