WellCAD Basics - Advanced Logic Technology

BOOK 1 - WELLCAD BASICS - 113
Gamma Ray and Transit Time. If the Add new logs from template is checked the
new layout will be applied to Caliper, Gamma Ray and Transit Time channels, a new
Lithology Log will be created according to the template information and the new
Formula Logs will be created as well. If the formula logs use Caliper, Gamma Ray or
Transit Time as source logs data values will be computed automatically.
If the Add new logs from template option stays unchecked, the new logs are not
created and gaps occur in the Borehole Document where the new logs would have
been placed.
Add new annotation layers from template:
Whether an annotation layer is created from a template or not depends on the Add
new annotation layers from template settings. If the option is checked annotation
layers are created according to the information provided by the template (see also
1.6 Annotations).
Apply display settings to annotations:
Each annotation layer stores a set of default presentation settings for the annotation
and engineering symbols. To apply these defaults to an existing annotation layer
when loading a template the Apply display settings to annotations option must
be checked.
Keep existing charts in the document:
If you have cross-plot charts stored within your current document, you can decide
whether they will be overwritten with the information coming from the template
(option not checked) or not (option checked).
Add new charts from template:
If you want to add cross-plots stored within the template to your current borehole
document check this option.
The display settings of a particular log stored in the template can only be applied to
a log in the Borehole Document if the log type and the log titles are the same. Each
log found in the document will be compared to the logs of the same type contained
in the template. If the titles match the new display style will be applied. If not, the
following dialog box pops up.