WellCAD Basics - Advanced Logic Technology

APPENDIX A - 481
Display Internal/External:
Check the appropriate option to enable the internal or external reference circle
display.
Radius:
Set a value for the reference circle radius.
Shading:
Different shading modes are available. If the Inside option is checked the area
between reference circle and cross-section will be shaded if the radius of the cross
section is smaller than the reference radius. If you select the Outside option only
areas outside of the reference circle would be shaded where the radius of the cross
section is larger than the reference radius.
Style:
Select a shading color and style from color picker and Style control.
Editing Methods:
The cross section box interval can be set in the Tabular Editor. You can also use
your mouse to insert a new box or change the position of existing ones directly in
the log column.
Inserting A New Box:
� Select the log.
� Move your mouse into the log column and hold down the Shift key.
� Single click if you want a cross section at a particular point or drag to create a
box covering a depth interval.
To delete a box simply press the CTRL key and click into the box that you want to
remove.
Editing Cross Section:
You can either enlarge or shrink the covered depth interval. To do so:
� Select the log.
� Move your mouse pointer into the vicinity of an interval border. If pinches
are displayed point to the depth the pinches point to, not the box border.
Your cursor will be displayed as double-sided vertical arrow.