WellCAD Basics - Advanced Logic Technology

428 - APPENDIX A
www.alt.lu
Title:
Enter the title that identifies the log. The title will be displayed in the Title area of
the log handle.
Diameter Scaling:
The Diameter Scaling gives you the option to select a scaled width for the log
column. The scaled width should be set to be greater than the widest borehole item
that you intend to place in the Engineering Log. The scale values that appear on the
log handle are one half (i.e. the radius) of the set diameter scaling value.
Example of 100 mm diameter scaling and 80 mm
For example, if the widest item is a drill hole of diameter 80 (mm) then the Diameter
Scaling needs to be set at, say 100 (using the same scale units as the drill item). This
will give a scale gap of 10 (mm) between the drill item and each edge of the
Engineering log column.
Position:
You can set the left and right position of the log column in selected units. The
default unit displayed is the one set for the Ruler Bar (see 1.3.2.4 Positioning Logs).
Display Style:
You can choose whether to display the entire well or just the left or right half of the
well.