WellCAD Basics - Advanced Logic Technology

164 - BOOK 1 - WELLCAD BASICS
www.alt.lu
Windows selected for the model
� In the Model Properties dialog box click the Add Element button located
in the upper right edge of the dialog box next. This will open the Insert
New Element dialog.
Select new element dialog box
Select an entry from the drop down list or enter a new name into the edit box of the
control. The information listed is read from the WellCAD.ini file [SpectralGamma]
section. You can add your customized entries to the WellCAD.ini when clicking the
Save Default button. If you wish to convert your spectral gamma process output
into other units than the calibration units, you may enter the conversion factor into
the corresponding edit box.
Commonly used weight percent conversion factors:
1 pCi (K-40)/g = 0.1195 wt-%K
1 pCi (Ra-226)/g = 2.997 wt-ppm eU