WellCAD Basics - Advanced Logic Technology

Inserting a new FWS Log:
APPENDIX A - 345
The only way to create a FWS Log is through file import. Various file formats are
supported. It is important for the processing of FWS data that during import the
time sampling rate is set correctly (measured in [�sec]). To check which time
sampling rate has been set open the Tabular Editor after your log has been created
and check the column titles. A default value for the time sampling rate can be set in
the FWS Log Default Settings.
Main Settings:
Full Wave Sonic Log Settings dialog box
Title:
Enter the title that identifies the log. The title will be displayed in the Title area of
the log handle.
Unit:
Insert the units of the amplitude scale. E.g. if spectral gamma data is handled in a
FWS Log container the unit could be counts or counts per second. Changing this
value has no effect on the data.
Amplitude Scale:
Adjust the low and high values of the signal amplitude to enhance the display of the
sonic traces on screen.