WellCAD Basics - Advanced Logic Technology

310 - APPENDIX A
www.alt.lu
Cross Hair Cursor assists in bed
alignment.
Press CTRL+L to toggle the cursor mode.
Changing bed boundaries and hardness:
� Select the Lithology Log.
� Move the cursor into the proximity of the bed boundary you want to
change.
� If the cursor changes to a double-sided arrow, click and drag the bed limit to
its new position. Note that bed boundaries will snap to each other
automatically if they are close enough.
To change the hardness expressed by the litho bed width the Bed Style must be set
to another value then Full. Simply move the mouse pointer to the vertical bed limit
and click and drag the boundary if the cursor changes to a horizontal double-sided
arrow.
Changing vertical and horizontal extend of a litho bed
Inserting a new non-repeated symbol:
As we will position the symbols with a single mouse click (there is no need to drag a
box) it is more convenient to select the type of symbol from the Litho Bar (see
Appendix B) prior to inserting the symbol.