WellCAD Basics - Advanced Logic Technology

Frame:
APPENDIX A - 443
If no Frame option has been selected, only the surface of the cylinder is rendered.
When Display Frame mode is checked, both the wire frame and the surface of the
cylinder are rendered. If only the wire frame should be displayed check the Display
Frame and Frame Only options.
3D Log without frame (left), with frame displayed (middle) and frame only (right) displayed
Cylinder Faces:
The number of faces used to render the 3D log cylinder is controlled by the angular
resolution of the component logs, whichever has the highest angular resolution.
However, it is possible to control the minimum number of faces used for rendering.
This can be helpful in the case when only low angular resolution data are available,
for instance while rendering a 3D log based only on a 4 arm caliper together with no
amplitude component. In that case, WellCAD uses an interpolation technique to
increase the number of angular data points.
Caliper:
If the caliper component log exists the low and high scale of the caliper can be set.
The minimum value corresponds to the geometrical center of the cylinder, while the
maximum value corresponds to the diameter of the cylinder that would completely
fill the available log column width.
Amplitude:
The behavior of the scaling and Palette button depends upon the type of
component, which is used for the amplitude.
The amplitude component is set to none:
When the amplitude component is set to none, the color used to render the surface
of the cylinder is constant. Therefore, the minimum and maximum values are
meaningless. The Palette button is used to set the cylinder surface color.