WellCAD Basics - Advanced Logic Technology

306 - APPENDIX A
www.alt.lu
Symbol shown in three different scales
Position:
You can set the left and right position of the log column in selected units. The
default unit displayed is the one set for the Ruler Bar (see 1.3.2.4 Positioning Logs).
Bed Style:
If you look at the data format of a Lithology Log you will notice that a Hardness
value can be recorded. It is usually a value between 0 and 1. If the Bed Style
parameter is set to another value than Full, the Hardness parameter is used to
determine the width of a pattern filled bed. This way normalized rock hardness, a
confidence index or any other information related to the lithology bed can be
shown.
Bed Style set to Full, Right, Both and Left
Style:
All lithology data is confined to beds that have a top depth and a bottom depth. A
lithology log in Primary style always displays the top and bottom bed boundaries
graphically as a straight line or with a user assigned contact line style.
With the Lithology Log in secondary style (non primary) the graphical representation
of bed limits is skipped. Further, non-repeated symbols are not clipped if their size
exceeds the bed extension.