WellCAD Basics - Advanced Logic Technology

472 - APPENDIX A
www.alt.lu
Editing Methods:
The Polar & Rose box interval can be set and a description can be added using the
Tabular Editor. You can also use your mouse to insert a new box or change the
position of existing ones directly in the log column.
Inserting a New Box:
� Select the log.
� Move your mouse into the log column and hold down the Shift key.
� Single click if you want a cross section at a particular point or drag to create a
box covering a depth interval.
To delete a box simply press the CTRL key and click into the box that you want to
remove.
Editing Polar & Rose Boxes:
You can either enlarge or shrink the covered depth interval. To do so:
� Select the log.
� Move your mouse pointer into the vicinity of an interval border. If pinches
are displayed point to the depth the pinches point to, not the box border.
Your cursor will be displayed as double-sided vertical arrow.
� Click and drag the interval limit to its new position.
Changing Attribute Values (only in Polar Projection mode):
� Select the log.
� Move your mouse into a Polar & Rose box. Your cursor is displayed as
pen.
� Click and drag the mouse to encircle the poles for which you would like to
change the attribute values. Once the left mouse button is released the
polygon closes automatically and a dialog box to select a new attribute
value will be displayed. The values displayed depend on which attribute