DM1100™ DM Series™ Digital Mailing System Operator Guide
DM1100™ DM Series™ Digital Mailing System Operator Guide
DM1100™ DM Series™ Digital Mailing System Operator Guide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
4 • Running Mail<br />
Tips on Feeding<br />
Mail<br />
• Presealed Envelopes: If you are using presealed envelopes, make<br />
sure you press the Seal key on the IntelliLink® Control Centre and<br />
select Sealer off or the envelopes will jam.<br />
• Pieces of mail that are 5/8" thick: If you are running pieces of mail<br />
that are each 5/8” thick, you must run them one piece at a time. Do not<br />
stack them on the feed deck and attempt to feed them automatically -<br />
they will jam.<br />
• Puffy mail: Be sure to compress all "puffy" mail before placing it on the<br />
feed deck.<br />
• Portrait flats or light, easily damaged mail: You may want to reduce<br />
the speed at which the pieces of mail travel through the machine. To do<br />
this, press the Mode key, then press the right arrow key (speed) to<br />
change between normal and reduced speed.<br />
• Any mail with the flap on the opposite side: For mail where the indicia<br />
is located on the side opposite of the flap (the flap is on the bottom<br />
of the mail piece), make sure the mail is completely sealed before processing<br />
the mail in the WOW mode as shown below..<br />
if this is where you want the<br />
indicia ...<br />
make sure the mail is completely<br />
sealed<br />
Flap face-down<br />
and sealed<br />
• Postcards: You may want to process postcards using the reduced<br />
speed mode.<br />
4-8 SV62220 Rev. A