DM1100™ DM Series™ Digital Mailing System Operator Guide

2
Connecting
Your
IntelliLink®
Control
Centre to an
Analog
Phone Line
Connecting Your
Mailing System
to a Remote
Analog Phone
Line
DM1100 Digital Mailing System Operating Guide
Which connector do I use?
Internal Analog Phone Line Connector - Use the internal analog modem
to connect directly to an analog phone line.
If your mailing system is not located near an analog phone line and you
need to remove the control centre when you perform feature updates or
add postage, refer to Connecting Your IntelliLink® Control Centre to a
Remote Analog Line in this section.
Internal Analog Phone
Line Connector
Use this to connect
directly to an analog
phone line
IntelliLink® Control Centre installed on a DM1100 Digital Mailing System base.
Dotted line indicates AC Adapter Receptacle is covered by base
If you need to connect to an analog phone line that is not located near your
mailing system, you can remove the IntelliLink® Control Centre and move it
to a location near the analog phone line. At the remote location, plug one
end of the AC Adapter (P/N 1C85005) into the back of the control centre
and the other end into an AC outlet.
To remove the control centre and move it to another location:
1. Turn off the power to the mailing system.
2. Pull the blue lever at the right of
the control centre towards you.
3. Slide the control centre forward
to remove it.
4. Take the control centre to
where the analog phone line is.
5. Connect the telephone cord
(AWG 26) from the internal
analog connector to the analog
telephone line.
6. Connect the A/C Adapter (P/N
1C85005) to the back of the
control centre and plug it into
an AC outlet.
Pull the blue lever forward to
release the control centre
SV62220 Rev. A 6-5