Configuring Hardware and Communication Connections STEP 7.pdf

Configuring Connections
12.12.3.4 Deleting One or More Connections
Requirement:
Procedure
You must be in the network view of NetPro.
1. Select the connections you wish to delete.
2. Select the menu command Edit > Delete.
If local ID and partner ID for the connection were entered in the connection
table, STEP 7 also deletes the connection in the table for the connection
partner.
3. Download the connection tables with the deleted connections to the relevant
programmable module. (To delete all the connections of a programmable
module, you must download an empty connection table to the module.)
12.12.3.5 Copying Connections
Introduction
Connections are not copied individually but always in context with the project or the
station.
You can copy the following:
• Entire projects
• One or more stations within a project or beyond the boundaries of a project
Requirement
The SIMATIC Manager must be open.
Copying a Project
When you copy a project, all configured connections are also copied. There are no
settings required for the copied connections because the connections remain
consistent.
Copying a Station
When you copy one or more stations within the project boundaries or beyond them,
you may have to reassign the connection partners to the local node (modifying a
connection).
If no connection partner exists for a connection, you will see this in the connection
table, since the row of the connection partner will be displayed in bold.
Connections between stations that are copied beyond the project boundaries
remain in tact and consistent if the relevant subnets between these stations are
copied along with them.
Configuring Hardware and Communication Connections with STEP 7
12-32 A5E00706939-01