Configuring Hardware and Communication Connections STEP 7.pdf

17.3 Changing M-Data in the SIMATIC Manager
Requirements
Procedure
• The module must support I&M data.
Commissioning and Service
• Τhere is an online connection through PROFIBUS ("Accessible Nodes") to the
module.
To edit M data (such as the Plant ID), proceed as follows:
1. Select the module in the "Accessible Nodes" window, and then select the
PLC > Change Module Identification menu command.
2. In the "Change Module Identification" dialog, change the M-data as required.
For redundant modules, you must edit the data for both the left and right
module.
3. To transfer this new data to the module, select the "Include" check box.
4. Confirm your settings with "OK".
The M data will be transferred to the module
Configuring Hardware and Communication Connections with STEP 7
A5E00706939-01 17-5