Configuring Hardware and Communication Connections STEP 7.pdf

Configuring Central Racks
2.3.13 Configuring S5 Modules
You can insert S5 modules in a SIMATIC 400 station. These modules are
connected via:
• An S5 adapter module (IM 470) or
• An IM 463-2 for connecting S5 expansion devices with IM 314
You can find these modules in the "Hardware Catalog" window under "IM 400."
Note
You must configure the input or output address areas of the S5 modules for each
connection. (Double-click the adapter module or IM 463-2 and then select the
"Input Addresses" or "Output Addresses" tab.)
If the address areas are not configured, the modules mentioned above will not be
saved in the system data blocks (SDB). Result: The configuration which was
downloaded to the CPU will not contain information about these modules. If this
configuration is uploaded to the programming device, these modules will not
appear in the configuration table.
Configuring Hardware and Communication Connections with STEP 7
2-18 A5E00706939-01