Undergraduate Catalogue - UPRM

COLLEGE OF ENGINEERING
INEL 4217. MICROPROCESSOR INTERFACING.
Three credit hours. Three hours of lecture per
week. Prerequisites: INEL 4206.
Interfacing of the microprocessor with devices such
as: cathode ray tube (CRT), floppy disks, hard
disks, direct memory access unit (DMA), interrupt
controller, timers, modems, magnetic tape units,
keyboards, analog to digital (A/D) and digital to
analog (D/A) converters. Emphasis in the hardware
and software design.
INEL 4225. DIGITAL ELECTRONICS
LABORATORY. One credit hour. One three-hour
laboratory per week. Prerequisites: INEL 4211.
Co-requisite: INEL 4207.
Experiments with digital electronic circuits and
analog gates.
INEL 4301. COMMUNICATIONS THEORY I.
Three credit hours. Three hours of lecture per
week. Prerequisite: INEL 4102.
Components and communications systems; Fourier
transform analysis of filtered signals; Nyquist
theorem; analog to digital and digital to analog
conversion processes; bandwidth; modulation and
noise. Computer-aided analysis.
INEL 4305. TELECOMMUNICATIONS
ELECTRONICS I. Three credit hours. Two hours
of lecture and one two-hour laboratory per week.
Prerequisites: INEL 4201. Corequisite: INEL
4202.
Impedance matching circuits; radio frequency
amplifiers; filters; oscillators; mixer circuits.
INEL 4307. COMMUNICATION BETWEEN
COMPUTERS. Three credit hours. Three hours of
lecture per week. Prerequisites: INEL 4301, INEL
4206 and (ININ 4010 or ININ 4011).
Computer network organization. Characteristics of
voice grade channels used for digital
communication. Synchronization and multiplexing.
Information codes and interfacing standards and
protocols. Data encription techniques. Distributed
computing and local area networks.
INEL 4405. ELECTRIC MACHINES. Three
credit hours. Three hours of lecture per week.
Prerequisite: INEL 4103.
Electromechanical energy conversion; induction,
synchronous and direct current machines.
INEL 4406. ELECTRIC MACHINES
LABORATORY. One credit hour. One three-hour
laboratory per week. Prerequisites: INEL 4115
and INEL 4103. Co-requisite: INEL 4405.
Magnetic circuits; single phase transformers; three
phase systems: load and transformers; single-phase
and three-phase induction motors.
INEL 4407. ELECTRICAL SYSTEMS DESIGN
I. Three credit hours. Three hours of lecture per
week. Prerequisite: INEL 4103.
Design of electrical systems for buildings; wiring
systems, illumination, protection and grounding.
INEL 4408. ELECTRICAL SYSTEMS DESIGN
II. Three credit hours. Three hours of lecture per
week. Prerequisite: INEL 4103.
Design of electrical systems for buildings: exterior
illumination, signal systems, and
emergency/standby power equipment.
INEL 4409. ILLUMINATION ENGINEERING.
Three credit hours. Three hours of lecture per
week. Prerequisite: INEL 4103 or INEL 4075.
Interior and exterior illumination design.
Development and application of methods on
illumination techniques.
INEL 4415. POWER SYSTEM ANALYSIS.
Three credit hours. Three hours of lecture per
week. Prerequisite: INEL 4103.
Formulation of bus admittance and bus impedance
matrices, symmetrical components, symmetrical
and unsymmetrical faults, load flow, economic
operation of power system.
INEL 4416. POWER ELECTRONICS. Three
credit hours. Three hours of lecture per week.
Prerequisite: INEL 4201 and INEL 4103.
Design of circuits for rectification, inversion,
frequency conversion, direct current (D.C.) and
alternating current (A.C.) machines control, and
other non-motor applications using solid state
power devices.
INEL 4505. INTRODUCTION TO CONTROL
SYSTEMS. Three credit hours. Three hours of
lecture per week. Prerequisite: INEL 4102.
Analysis of control systems and their mathematical
models; analysis and design of control systems for
single-input single-output plants; computer solution
of problems will be emphasized.
Undergraduate Catalogue 2004-2005 299