Flamenco Technical Manual Revision 6.0 - Tunstall.de

5. Installation work sequence
Work step
Description
1. Defining the mounting positions Page 43 and the following.
2. Installation of back boxes Page 49 and the following.
3. Laying the cables Page 51 and the following.
4. Mounting and connecting of devices Refer to chapter “Product
leaflets“, page 83 and the
following.
5. Switching on and checking of power supply Page 61 and the following.
6. Configuring the room terminals (ComTerminal
Flamenco, RoomTerminal Flamenco, ControlTerminal
Flamenco, ControlTerminal with doorplate
Flamenco)
7. Configuring OSY-ControlCenter
(SystemOrganizer)
ComTerminal Flamenco,
RoomTerminal Flamenco:
Refer to chapter “Product
leaflets“, page 83 and the
following.
ControlTerminal Flamenco,
ControlTerminal with doorplate
Flamenco: Refer to
online help included with
the ControlTerminal Config‐
Set (order no. 77 0920 00).
Page 63 and the following.
8. Connecting the OSY-ControlCenter Refer to chapter “Product
leaflets“, page 83 and the
following.
9. Commissioning the OSY-ControlCenter Refer to chapter “Product
leaflets“, page 83 and the
following.
10. Commissioning the ward console
(ComStation BUS-C , ComStation PC , ComStation CT
Flamenco) or ComStation T Flamenco
11. Connecting and commissioning the Management‐
Center
Refer to the documents
delivered with the ward console.
Refer to chapter “Product
leaflets“, page 83 and the
following.
12. Functional check of the system Page 69 and the following.
Flamenco - Technical Manual, 04/13 (Rev. 6.0), 00 8812 60
41