NZ4202 - Unitec
NZ4202 - Unitec
NZ4202 - Unitec
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
NZS 4202: 1 995 Issued June 1995<br />
36.4.4<br />
The following shall be measured separately:<br />
Glazing of irregular shape measured as the smallest rectangular size out of<br />
which the shape can be cut;<br />
Curved and bent glazing, stating the size of the pane and the radius of the<br />
bend or curve;<br />
Double or multiple glazing. Each layer shall be measured;<br />
--`,,``,,,,,,``,``,`,,,`,,,`,-`-`,,`,,`,`,,`---<br />
Sealed double glazing units shall be enumerated and approximate size<br />
stated;<br />
Louvre blades shall be measured in metres stating the number of blades and<br />
labours to edges;<br />
Leadlights and copperlights shall be enumerated stating the approximate<br />
size of the pane;<br />
Glazed doors, slides, mirrors (including backing material) splashbacks, and<br />
the like shall be enumerated. The description shall include all labours such as<br />
grinding to edges, forming finger recesses, drilling for hardware and the like,<br />
and the type of fixing.<br />
Circular cutting shall be measured in metres.<br />
36.4.6<br />
Where glazing is fixed in preformed bedding material, this material shall be<br />
measured separately in metres.<br />
36.4.7<br />
Polishing, grinding, bevelling of edges, and the like shall be measured in metres<br />
according to the total perimeter of the sheet to be worked as follows:<br />
(a)<br />
Not exceeding 4.0 m in perimeter;<br />
(b)<br />
(c)<br />
Exceeding 4.0 m and not exceeding 6.0 m in perimeter;<br />
Exceeding 6.0 m and not exceeding 9.0 m in perimeter;<br />
(d) Exceeding 9.0 m in perimeter.<br />
The thickness and number of panes in each classification shall be given in the<br />
description.<br />
36.4.8<br />
The jointing of glazing shall be measured in metres and the type of fixing or<br />
compound stated.<br />
36.4.9<br />
Silvering, embossing, etching, sand blasting and the like shall be enumerated stating<br />
the design, size and number of panes.<br />
36.4.10<br />
The cutting of holes, openingsand the like shall be enumerated stating both the size<br />
of opening and size of the pane.<br />
36-2<br />
Copyright Standards New Zealand<br />
Provided by IHS under license with SNZ<br />
Document provided by IHS Licensee=<strong>Unitec</strong> Inst of Technology/5911177001,<br />
03/02/2005 18:31:52 MST Questions or comments about this message: please call<br />
the Document Policy Group at 303-397-2295.