NZ4202 - Unitec
NZ4202 - Unitec
NZ4202 - Unitec
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
SNZ NZS*4202 75 m 8583369 0042546 527 m<br />
Issued June 1995 NZS 4202: 1995<br />
SECTION 29 - SOLID PLASTER<br />
29.1 OVERVIEW<br />
Refer to section O, General rules, which shall be read in conjunction with this section.<br />
29.2 PREAMBLES<br />
29.2.1 Rates to include<br />
(a)<br />
(b)<br />
Temporary rules, grounds, screeds and the like;<br />
Internal angles other than coved angles:<br />
--`,,``,,,,,,``,``,`,,,`,,,`,-`-`,,`,,`,`,,`---<br />
(c)<br />
29.3 GENERAL PRINCIPLES<br />
Making good around pipes, sanitary fittings and the like.<br />
29.3.1<br />
Solid plaster shall be described and the number of coats, composition and finished<br />
thickness shall be stated. The description shall include the preparation of surfaces<br />
to be plastered, and surface finish of plaster.<br />
29.3.2<br />
Exterior work shall be scheduled separately from interior work.<br />
29.3.3<br />
Plaster shall, unless otherwise required, be scheduled in square metres of surface<br />
area covered.<br />
29.4 MEASUREMENT PROCEDURE<br />
29.4.1<br />
Plaster on concrete, blockwork, brickwork, sheet foam insulation, backing board or<br />
other surfaces shall be each measured separately.<br />
29.4.2<br />
Plaster on lathing shall be measured separately and the description shall include the<br />
lathing .<br />
29.4.3<br />
Work to floors, walls and ceilings shall be measured separately. Work to floors to falls<br />
or crossfalls shall be so described. Work to sloping ceilings shall be measured<br />
separately.<br />
29.4.4<br />
Work to integral beams, perimeter of openings and to integral columns shall be<br />
measured with the wall or ceiling and this shall be stated.<br />
29.4.5<br />
Workto isolated beams and to isolated columns shall each be measured separately.<br />
29.4.6<br />
Beams or columns where the substrate or finish are different from the abutting<br />
ceilings or walls respectively shall be measured as isolated work.<br />
Copyright Standards New Zealand<br />
Provided by IHS under license with SNZ<br />
Document provided by IHS Licensee=<strong>Unitec</strong> Inst of Technology/5911177001,<br />
03/02/2005 18:31:52 MST Questions or comments about this message: please call<br />
the Document Policy Group at 303-397-2295.<br />
29-1