The_Rule_Book - Brooklyn Scouts, Wellington

2010 Edition
(g)
(3) Ensure that prior to entry on to a ballooning launching area all scouts
have received instruction as required by Clause (e) of these MSR’s
(4) Ensure that the pilot(s) in command, with whom the Scouts are to
fly, meet the requirement(s) of Clause (c) of these MSR’s.
(5) Ensure that the balloon in which any Scouts fly complies with the
requirements of Clause (d) of these MSR’s.
(6) Ensure that the Scouts are under the supervision and control of a
qualified balloon pilot or the holder of an Air Activities Charge
Certificate.
It is recognised that some or all of the requirements listed in Clause (f)(1)
- (6) of the above could be difficult for the Group Leader to check in some
instances. Therefore, in the event that the Group Leader does not have
access to a Regional or Zone Air Activities Adviser for consultation
concerning the requirements, it is essential that the assistance of an
appropriate authority at the National Office of SCOUTS New Zealand be
requested.
Note:
(a) Flying in powered aircraft, microlight aircraft and glider aircraft are covered
in separate MSR’s for powered aircraft, microlight aircraft and glider
aircraft respectively.
(b) To demonstrate compliance with these MSR’s it is recommended that prior
to undertaking the activity the leader of the activity and the pilot-incommand
sign the respective sections.
(c) CAA Rules may be viewed at www.caa.govt.nz
Management Procedures Page 51