Leica TPS1200 System Field Manual

22.4 Radios for Remote ControlDescriptionConfigureTCPS27/RH1200connectionstep-by-stepFor radios the channels on which the radio broadcasts can be changed. Changingchannels changes the frequency at which the radio operates. This may be necessaryto enable multiple pairs of radios to work simultaneously in the same area withoutinterferring with each other. The following radios for remote control support channelchanging:• TCPS27 • RadioHandleRefer to the stated chapter for more information on screens.Step Description1. Access CONFIGURE Interfaces.2. Highlight the interface RCS Mode with either RadioHandle or TCPS27attached as the device.3. CTRL (F4) to access CONFIGURE TCPS27 / RH1200.4. CONFIGURE TCPS27 / RH1200. The type of protocol, which is fixed as RCS. The assigned channel number (from 0 to 15).The link number for the RX1200 controller and the radio must be thesame. The communication settings for the RX1200 controller and theradio must also be same. The option Remote or Base are available.Remote sets the radio into remote mode.Base sets the radio into base mode.The radio modules inside the RX1200 controller and the radio must be setto opposite settings. It is recommended to set the RX1200 controller toRemote and the radio to Base.144 TPS1200+ Config...\Interfaces... - Controllingthe Device