Leica TPS1200 System Field Manual

Field Option Description• To start a new sequence of point ID’stype over the point ID.• For an individual point ID independentof the ID template SHIFTINDIV (F5). SHIFT RUN (F5)changes back to the next ID from theconfigured ID template.The linework flag to be stored with thepoint.- - - - - No linework flag is stored.Begin LineOpens a new line when the next point isstored. Any line/area which is currentlyopen is closed and the last pointbelonging to that line/area is given theEnd Line/Close Area linework flag. Thepoint may or may not be stored with apoint code.3pt Curve Stores the linework flag for a curvethrough three points and continues aline/area.ReOpen Any Line Opens a line from a list of all lines whichare currently stored in the job when thenext point is stored. The last code usedwith the reopened line is automaticallyselected when the point is stored. Anyline/area which is currently open is closedand the last point belonging to thatline/area is given theEnd Line/Close Area linework flag.ReOpen Last Line Opens the last used line again. The lastcode used with the reopened line is automaticallyselected when the point isstored.End Line Closes all open lines.Cont Line/Area Indicates a line/area is open.Start SplineEnd SplineCont SplineStores the linework flag for beginning aspline and continues any open line/area.Closes a spline and continues any openline/area.Indicates a line/area is open with splineline type.60 TPS1200+ Linework