Leica TPS1200 System Field Manual

MANAGEXX JobCoord SystempageMANAGEXX JobAvge pageChoosing a coordinate system attaches it to the job. All other fields on this screenare output fields. They depend on the transformation type of the selected coordinatesystem.Next stepPAGE (F6) changes to the Avge page.In order to check measurements, the same point can be measured more than once.If activated, an average or an absolute difference is calculated. Refer to paragraph"MANAGE XX Job, General page" for information on the softkeys.Description of fieldsField Option DescriptionDefines the averaging principles formultiple measured points.Average Computes the average for the positionand the height. Points exceeding thedefined limits are marked with inMANAGE Edit Point, Mean page.Absolute Diffs Computes the absolute differencesbetween two points selected from a list ofmeasured points which are all stored withthe same point ID.OffAveraging is turned off.Available for . The method used forcomputing the average.Weighted Computes a weighted average.No Weighting Computes an arithmetic average. Choicelist The type of points which will be taken intoaccount for averaging or for absolutedifferences.andFromtoUser inputUser inputAvailable for . The acceptable difference forthe position and height components.Available for . The acceptable absolutedifferences for each coordinate component.Next stepSTORE (F1) stores the job and returns to MANAGE Jobs (Device).38 TPS1200+ Manage...\Jobs