Leica TPS1200 System Field Manual

26.2 Configuring SmartStation for Using NTRIP Service26.2.1 Configuring an Access to the InternetRequirements • SmartStation must be used.• Firmware v2 or higher must be loaded on the TPS1200+ instrument.• Firmware v1.42 or higher must be loaded on the RX1200.To access to the Internet with SmartStation, General Packed Radio System deviceswill normally be used. GPRS is a telecommunication standard for transmitting datapackages using the Internet Protocol (IP).Configure accessto Internetstep-by-stepThe following table explains the most common settings. Refer to the stated chapterfor more information on screens.Step Description1. Select Main Menu: Config...\Interfaces....2. In CONFIGURE Interfaces highlight Internet.3. EDIT (F3) to access CONFIGURE Internet Interface.4. CONFIGURE Internet Interface Some providers ask for a user ID to allow connecting to theInternet via GPRS. Contact your provider if a user ID needs to be used. Some providers ask for a password to allow connecting tothe Internet via GPRS. Contact your provider if a password needs to beused.5. DEVCE (F5) to access CONFIGURE GSM/Modem Devices.6. CONFIGURE GSM/Modem DevicesHighlight the GPRS device to be used.NEW (F2) to create a new device.7. CONT (F1) to return to CONFIGURE Internet Interface.8. CONT (F1) to return to CONFIGURE Interfaces.9. CTRL (F4) to access CONFIGURE XX Connection.10. CONFIGURE XX ConnectionType in relevant information.CODES (F3) Available for digital cellular phones of GSM technology. Toenter the Personal Identification Number of the SIM card. If the PIN islocked for any reason, for example the wrong PIN was entered, input thePersonal UnblocKing code for access to the PIN.11. CONT (F1) to return to TPS1200+ Main Menu.The instrument is now online to the Internet. The Internet online statusicon is displayed. But because GPRS is being used, no charges are yetmade since no data transfer from the Internet has yet taken place.194 TPS1200+ NTRIP via Internet