Leica TPS1200 System Field Manual

8.2.2 Mean PageDescription • Various measured coordinate triplets for one point can be recorded using thesame point ID. If the averaging mode is activated, an average is calculated.• It is checked if the deviations of each single point are within the configured limits.• After averaging, the Mean page becomes available in MANAGE Edit Point:Point ID and accessible from the Survey application program SURVEY Survey:Job Name, Survey page.AveragingDefining the averaging mode and configuring the limitsThe averaging mode and the limits are configured in MANAGE New Job, Avgepage or in MANAGE Edit Job: Job Name, Avge page. Refer to "7.2 Creating a NewJob/Editing a Job" for further details.Description of averaging modesAveraging modeAverageAbsolute DiffsOffDescriptionThe horizontal and height distances from the measured pointsto the average are computed and displayed on the Meanpage. Depending on the selected averaging method, theaverage will be computed weighted or arithmetic (noweighting).The same as for Average above applies for Absolute Diffs.Additionally, the absolute difference between two pointsselected from a list of measured points which are all storedwith the same point ID are computed and checked for beingwithin the defined limits.Averaging functionality is turned off.Accessstep-by-stepAccess within data managementStep Description1. Refer to "6 Manage... - Getting Started" to access MANAGE Data: JobName.2. In MANAGE Data: Job Name, Points page highlight a point to be edited.3. EDIT (F3) to access MANAGE Edit Point: Point ID, Mean page.44 TPS1200+ Manage...\Data