Leica TPS1200 System Field Manual

26.2.3 Using the NTRIP Service with SmartStationRequirementsUse NTRIP servicestep-by-stepThe configurations from the previous chapter must have been completed. Refer to"26.2.2 Configuring to Connect to a Server".Step Description1. Select Main Menu: Config...\Interfaces....2. In CONFIGURE Interfaces highlight GPS RTK.3. EDIT (F3) to access CONFIGURE Real-Time Mode.4. CONFIGURE Real-Time Mode must be selected.5. ROVER (F2) to access CONFIGURE Additional Rover Options.6. PAGE (F6) to access CONFIGURE Additional Rover Options, NTRIPpage.7. CONFIGURE Additional Rover Options, NTRIP page8. A user ID is required to receive data from to the NTRIPCaster.Contact the NTRIP administrator for information. A password is required to receive data from the NTRIP-Caster. Contact the NTRIP administrator for information.9. SRCE (F5) to access CONFIGURE NTRIP Source-Table.10. CONFIGURE NTRIP Source-TableAll MountPoints are listed. MountPoints are the NTRIP servers sending outreal-time data. This screen consists of two columns:First column MountPoint:The abbreviations for the MountPoints.Second column Identifier:The city where the MountPoint is located.Highlight a MountPoint about which more information is required. Thisinformation helps to configure SmartStation to use the selected Mount-Point as a reference.11. INFO (F3) to access CONFIGURE MountPoint: XX.12. CONFIGURE MountPoint: XX, General page The real-time data format sent out by the MountPoint. Details about , for example the RTCM messagetypes including update rates in seconds displayed in brackets. The type of password protection required for the authorisationto the NTRIPServer. if no password is required. if the password need not be encrypted. if the password must be encrypted. Indicates if the MountPoint must receive GGA NMEA data fromthe rover in order to compute VRS information.198 TPS1200+ NTRIP via Internet