Leica TPS1200 System Field Manual

26.2.2 Configuring to Connect to a ServerRequirementsConfigure connectto a serverstep-by-stepThe configurations from the previous chapter must have been completed. Refer to"26.2.1 Configuring an Access to the Internet".Step Description1. Select Main Menu: Config...\Interfaces....2. In CONFIGURE Interfaces highlight GPS RTK.3. EDIT (F3) to access CONFIGURE Real-Time Mode.4. CONFIGURE Real-Time Mode Select the type of data to be received from the Internet.5. CONT (F1) to return to CONFIGURE Interfaces.6. Highlight GPS RTK.7. CTRL (F4) to access CONFIGURE Set NET Port.8. CONFIGURE Set NET Port The server to be accessed in the Internet. Opening thechoicelist accesses CONFIGURE Server to Connect where new serverscan be created or existing servers can be selected or edited. The IP address of the server to be accessed in theInternet. The port of the Internet server through which the data isprovided. Each server has several ports for various services. Allows for automatic connection between theSmartStation and the Internet when a point is occupied during a survey.Ending the point occupation also ends the Internet connection.9. CONT (F1) to return to CONFIGURE Interfaces.Once SmartStation is connected to the server a message is displayed inthe message line.10. CONT (F1) to return to TPS1200+Main Menu.11. USER12. STAT (F3) to access STATUS Status Menu.13. Highlight Interfaces....14. ENTER to access STATUS Interfaces.15. STATUS InterfacesHighlight GPS RTK.16. DEVCE (F5) to access STATUS Device: Ethernet.17. STATUS Device: Ethernet196 TPS1200+ NTRIP via Internet