Leica TPS1200 System Field Manual

17.3 Coding & Linework SettingsDescriptionAccessCONFIGURECoding &Linework,Coding pageThe settings on this screen define the method of coding. For information on configuringand using SmartCodes refer to TPS1200+ Technical Reference Manual.Select Main Menu: Config...\Survey Settings...\Coding & Linework Settings.Description of fieldsField Option Description Never, On orOffDetermines if quick coding is never available,activated or available but deactivated. 1, 2 or 3 Available unless .Sets the mostly used number of digits for thequick code. After Point orBefore PointDefault Valuesor Last UsedAlwaysPromptOnly If NoValueCode ChangeOnlyWith CodelistWithoutCodelistOnly Pt Codesor All CodesAvailable unless .Determines if a free code measured with aquick code is stored before or after the point.Determines the attribute values displayedunder certain circumstances. This is applicableto both the storing and displaying ofattribute values.The screen XX Enter Mandatory Attributewill always appear when codes, having oneor more attributes of attribute type mandatory,are being stored.The screen XX Enter Mandatory Attributewill only appear when codes, having one ormore attributes of attribute type mandatory,are being stored without an attribute value.The screen XX Enter Mandatory Attributewill only appear when a new code with amandatory attribute was selected.Codes stored within the job codelist can beselected to code points, lines and areas.Codes stored within the job codelist cannotbe selected to code points, lines and areas.Each code must be entered manually.Either only point codes or all codes of the jobcodelist will be available in the choicelist for/ in a display maskof an application program. Selecting aline/area code opens a new line/area. Choicelist Available for .When this field is active, surveyed points thathave the same code attached are strung toone line.Config...\Survey Settings... TPS1200+ 95