Leica TPS1200 System Field Manual

StepDISTRECALLDescription(F2) to measure a distance and to display the distance and theangles. The update of the vertical angle after DIST (F2) depends on thesetting of in CONFIGURE Units & Formats, Angle page.• For the vertical angle remains fixed untilREC (F3) is pressed.• For the vertical angle is continuously updatedaccording to the telescope movement.(F3) to store either the displayed distance if measured with DIST (F2)and angles or angles and no distance. The displayed point ID is increasedaccording to the active point ID template. After REC (F3) is pressed, thedistance related values are cleared.(F1) to measure and store distance and angles. The displayed pointID is increased according to the active point ID template. After ALL (F1)is pressed, the distance related values are cleared. Pressing ALL (F1)works in the same way as pressing DIST (F2) and then REC (F3).4. ALL (F1) to measure distance and angles.Combining DIST(F2) and REC (F3)step-by-stepThe key combination of DIST (F2) and REC (F3) can be used to measure non accessiblepoints with the reflector, for example building corners.TPS12_039TPS12_040Step Description1. Position the reflector at the same distance from the instrument as thebuilding corner to be measured.2. DIST (F2) to measure the distance.3. REC (F3) to store the measured distance to the reflector and the anglesto the corner of the house.For measurements without reflector must be set.For , continuous distance measurements are executedonce ALL (F1) or DIST (F2) is pressed.30 TPS1200+ Setup, Measure and Record