M16C/62 Group DATASHEET

Mitsubishi microcomputersM16C / 62 GroupSINGLE-CHIP 16-BIT CMOS MICROCOMPUTERRevision HistoryVersionContents for changeRevisiondateREV.H2 Page 8 CNVSS pin function Line 199.11.2Page 8 BYTE pin function Line 1Page 10 Figure 1.4.1Add Note 3Page 18 to 20 Figure 1.7.1 to Figure 1.7.3Add to “ Note : Locations in the SFR area where nothing is allocated are reservedareas. Do not access these areas for read or write. ”________Page 44 Table 1.13.2 BHE Status________Page 45 Table 1.13.3 BHE StatusPage 62 Interrupt Line 6Page 67 Address Match Interrupt Line 6Page 117, 123, 130 UARTi Transmit/receive Mode Register Bit 3 (Internal/external ClockSelect Bit) FunctionPage 146 Line 5Bit 1 of the UART2 special mode register 2 (address 036716) -->Bit 1 ofthe UART2 special mode register 2 (address 037616)Page 175 Table 1.23.2 and Figure 1.23.10 BCLK pin connectionPage 234 Flash memory Version Table 1.28.13V version: 2.4V to 3.6V (The bottom aim is 2.2V) -->3V version: 2.4V to 3.6VREV.H3 Page 399.11.25__P81/TA4IN/U --> P81/TA4IN/U__P80/TA4OUT/U --> P80/TA4OUT/UREV.H4 Page 150 Note 2• Before data can be written to the SI/Oi transmit/receive register (addresses036016, 036416), the CLKi pin input must be in the low state. Also, before rewritingthe SI/Oi Control Register (addresses 036216, 036616)’s bit 7 (SOUTi initial valueset bit), make sure the CLKi pin input is held low. ---> • Before data can be writtento the SI/Oi transmit/receive register (addresses 036016, 036416), the CLKi pininput must be in the high state. Also, before rewriting the SI/Oi Control Register(addresses 036216, 036616)’s bit 7 (SOUTi initial value set bit), make sure the CLKipin input is held high.99.12.21Revision historyM16C/62 Group data sheet273