M16C/62 Group DATASHEET

Mitsubishi microcomputersM16C / 62 GroupSINGLE-CHIP 16-BIT CMOS MICROCOMPUTERVersionContents for changeRevisiondateREV.H5 Page 34, Table 1.12.200.7.4_______Normal mode, microprocessor mode, CS0 area0300016 to FFFFF16 --->3000016 to FFFFF16_______Expansion mode 1, microprocessor mode, PM13=1, CS0 area0600016 to FFFFF16 --->0600016 to BFFFF16Page 49, Figure 1.13.6Note: Writing a value to an address after “1” is written to this bit returns the bit to“0” . Other bits do not automatically return to “0” and they must thereforebe reset by the program.Page 149, Figure 1.19.32, bit 5 of the SI/Oi control register (i=3, 4)Transfer direction lect bit --->Transfer direction select bitPage 149, Figure 1.19.32, Note 2When using the port as an input/output port by setting the SI/Oi port select bit (i =3, 4) to “1”, be sure to set the sync clock select bit to “1”.--->When using the port as an input/output port by setting the SI/Oi port select bit (i =3, 4) to “0”, be sure to set the sync clock select bit to “1”.Page 198, Table 1.26.23, tCONV9.8 (Min) VCC(Max) --->9.8 (Min)REV.H6 Page 34, Table 1.12.201.2.16_______Expansion mode 1, microprocessor mode, PM13=1, CS0 area0600016 to BFFFF16 --->0600016 to FFFFF16Revision historyM16C/62 Group data sheet274