NASA Scientific and Technical Aerospace Reports

Plasma Interactions With a Negative Biased
Electrodynamic Tether – 324
Simulations of Solar Wind Plasma Flow
Around a Simple Solar Sail – 325
Solar Array Arcing in LEO How Much
Charge is Discharged? – 328
PLASMA PHYSICS
Basic Studies in Plasma Physics – 298
Modification of the Coherence Properties
of a Laser Beam by a Plasma – 291
PLASMA POTENTIALS
ISS Plasma Interaction: Measurements
and Modeling – 294
PLASMA PROBES
Current Collection by a Segmented
Langmuir Probe in the Ionosphere
Plasma – 43
PLASMAS (PHYSICS)
A Review of Spacecraft Effects on
Plasma Measurements – 33
Active Spacecraft Potential Control for
Cluster Results from Three Years in Orbit
– 42
Anomalous Skin Effect for Anisotropic
Electron Velocity Distribution Function
– 298
Basic Studies in Plasma Physics – 298
Design of a New Modular Spacecraft
Plasma Interaction Modeling Software
(SPIS) – 239
Development of Compact Quasi-
Axisymmetric Stellarator Reactor Configurations
– 298
Feasibility Study of an Experimental Platform
With Active Plasma Emission for
Japan Experimental Module Onboard
ISS – 34
Ground-Based Simulation of Low-Earth
Orbit Plasma Conditions: Plasma Generation
and Characterization – 295
High Voltage Solar Array for 400V Operation
in LEO Plasma Environment – 37
MHD Ballooning Instability in the Plasma
Sheet – 299
Modeling of the Photoelectron Sheath
Around an Active Magnetospheric
Spacecraft With PicUp3D – 317
Modeling of the Plasma Thruster Impact
on Spacecraft Charging – 37
Onset of Spacecraft Charging in Single
and Double Maxwellian Plasmas in
Space: A Pedagogical Review – 316
Plasma Phenomena Associated With Solar
Array Discharges and Their Role in
Scaling Coupon Test Results to a Full
Panel – 30
Solar Array Arcing in LEO How Much
Charge is Discharged? – 328
Wake Effects on Positively Charged
Spacecraft in Flowing Tenuous Plasmas:
Cluster Observations and Modeling
– 39
PLASTIC DEFORMATION
High Strain Rate Superplastic Behavior
of Al-Li-Mg- Cu-Sc Alloy Subjected to
Severe Plastic Deformation – 75
Nanostructured Materials Produced by
Severe Plastic Deformation – 74
PLATES (STRUCTURAL MEMBERS)
Accurate Simulation of Acoustic Emission
Sources in Composite Plates – 61
Implementation of Higher Order Laminate
Theory Into Strain Rate Dependent
Micromechanics Analysis of Polymer Matrix
Composites – 60
SUS: Survivability after Underwater
Shock: Implementation of Whipping
Bending Moment and Hull Plate Dishing
– 134
PLUMES
Modeling of the Photoelectron Sheath
Around an Active Magnetospheric
Spacecraft With PicUp3D – 317
Numerical Modeling of ISS Thruster
Plume Induced Contamination Environment
– 269
PLUTONIUM
Evaluation of the Effects of Tank 50H
Solids on Dissolved Uranium, Plutonium
and Neptunium – 285
Investigation of Plutonium and Uranium
Precipitation Behavior with Gadolinium
as a Neutron Poison – 85
POLARITY
Determine the Mechanism by which Specific
ERbB Receptor Dimers Differ in
Their Ability to Disrupt Epithelial Cell Polarity
– 219
POLICIES
Determination and Applications of Environmental
Costs at Different Sized Airports:
Aircraft Noise and Engine Emissions
– 158
Long-Term Stewardship of Globally-
Distributed Representation Information
– 311
Reducing Storage Management Costs
via Informed User-Based Policies – 257
Regulation, Competition and Network
Evolution in Aviation – 305
POLISHING
pH and Resistivity of the BCP Mix Diluted
in UPW – 281
Single Step Lapping and Polishing Process
for Achieving Surfaces of Compound
Semiconductors with Atomic Flatness
using a Sub-micron Agglomeratefree
Alumina Slurry – 80
POLLEN
NTT Technical Review – 152
POLLUTION TRANSPORT
Sources of Tropospheric Ozone along
the Asian Pacific Rim: An Analysis of
Ozonesonde Observations – 148
POLYCHLORINATED BIPHENYLS
In Situ Remediation of Polychlorinated
Bephenyls Using Palladium Coated Iron
or Magnesium – 153
POLYCRYSTALS
CuInS2 Films Deposited by Aerosol-
Assisted Chemical Vapor Deposition Using
Ternary Single-Source Precursors
– 50
Large-Scale PV Module Manufacturing
Using Ultra-Thin Polycrystalline Silicon
Solar Cells. Annual Subcontract Report 1
April 2002-30 September 2003 – 143
Synchrotron X-ray Microdiffraction Analysis
of Proton Irradiated Polycrystalline
Diamond Films – 302
POLYETHYLENES
Inter and Intra Molecular Phase Separation
Environment Effects on PI-PEO
Block Copolymers for Batteries and Fuel
Cells – 81
POLYIMIDE RESINS
In-Plane Shear Testing of Medium and
High Modulus Woven Graphite Fiber
Reinforced/Polyimide Composites – 53
Studies on Hot-Melt Prepregging of
PMR-II-50 Polyimide Resin with Graphite
Fibers – 53
The Influence of Sizings on the Durability
of High-Temperature Polymer Composites
– 53
POLYIMIDES
Carbon Nanofiber-Filled Materials for
Charge Dissipation – 79
Effect of Sizings on the Durability of High
Temperature Polymer Composites – 17
Effects of Fiber Reinforcement Architecture
on the Hygrothermal-Mechanical
Performance of Polyimide Matrix Composites
for Aeropropulsion Applications
– 58
Heat, Moisture and Chemical Resistant
Polyimide Compositions and Methods for
Making and Using Them – 51
Solar Sail Material Performance Property
Response to Space Environmental Effects
– 82
POLYMER MATRIX COMPOSITES
Accelerated Testing of Polymeric Composites:
Correlation of Scale-up Effects
on Viscoelastic Behavior – 57
Effects of Fiber Reinforcement Architecture
on the Hygrothermal-Mechanical
Performance of Polyimide Matrix Composites
for Aeropropulsion Applications
– 58
Implementation of Higher Order Laminate
Theory Into Strain Rate Dependent
Micromechanics Analysis of Polymer Matrix
Composites – 60
The Influence of Sizings on the Durability
of High-Temperature Polymer Composites
– 53
Thermomechanical Properties of M40J
Carbon/PMR-II-50 Composites – 52
A-53