Liebert® IntelliSlot® Modbus 485, Modbus IP and BACnet IP

More documents

Recommendations

Info

Table 76 Liebert CRV - Glossary (continued) 234 BACnet Communications - Precision Cooling Products Enable/disable the activation of the [Shutdown - Loss Of Power] event. If set Shutdown - Loss Of Power - Event Control to 'disabled', the event will not be annunciated. This implies that the event will not be placed in any active event list or in any event history list. Shutdown - Loss Of Power - Event Type The event type for the [Shutdown - Loss Of Power] event. Shutdown - Loss Of Power System lost power. This event becomes active when the unit is powered on following an unexpected loss of power. This event remains active for 90 minutes. Smoke Detected - Event Control Enable/disable the activation of the [Smoke Detected] event. If set to 'disabled', the event will not be annunciated. This implies that the event will not be placed in any active event list or in any event history list. Smoke Detected - Event Type The event type for the [Smoke Detected] event. Smoke Detected Smoke detected. Supply Air Over Temp Threshold Threshold value used in the [Supply Air Over Temperature] event. Supply Air Over Temperature Supply air high temperature event. Supply Air Sensor Issue The air sensor at the outlet of the unit is disconnected or the signal is out of range. Supply Air Temperature Air temperature measured at the outlet of the unit. Supply Air Under Temp Threshold Threshold value used in the [Supply Air Under Temperature] event. Supply Air Under Temperature Supply air low temperature event. Supply Chilled Water Loss of Flow Supply chilled water flow is too low. Supply Chilled Water Over Temp Threshold Threshold value used in the [Supply Chilled Water Over Temp] event. Supply Chilled Water Over Temp [Supply Chilled Water Temperature] has exceeded [Supply Chilled Water Over Temp Threshold]. Supply Chilled Water Temperature Supply chilled water temperature. Supply Fluid Temp Sensor Issue The supply fluid temperature sensor is disconnected or the signal is out of range. Supply Humidity Relative humidity at the outlet of the unit. System Control Mode System control mode. System Date and Time The system date and time System Event Acknowledge/Reset Reset and/or acknowledge all events. System On/Off Control Turn system functionality on or off. System Operating State Reason The reason the system is in the current operating state. System Operating State Current operating state of the system. System Status The operating status for the system Top Fan Issue The top fan is not operating within its normal parameters. Unit Off Unit was turned off. Unit On Unit was turned on. Unit Partial Shutdown Data Description Description An event has occurred requiring some system components to be shutdown and disabled. Unit Shutdown An event has occurred requiring the unit to be shutdown and disabled to prevent damage to the system. Unit Standby Unit was placed in standby mode. Water Leakage Detector Sensor Issue The water leakage detector sensor is disconnected or the signal is out of range.
Table 77 Liebert HPC - Binary Data Compressors Controller Liebert iCOM v4 Data Description Object Type 235 BACnet Communications - Precision Cooling Products Instanc e Object Name Access Notes Compressor Not Stopping Binary_Value 1 5263_1 RD Compressor Superheat Over Threshold Binary_Value 2 5604_1 RD Compressors - Compressor 1 Compressor Hours Exceeded Binary_Value 12 5269_1_1 RD Compressor High Head Pressure Binary_Value 13 5270_1_1 RD Compressor Low Suction Pressure Binary_Value 14 5271_1_1 RD Compressor Thermal Overload Binary_Value 15 5272_1_1 RD Compressor Low Oil Pressure Binary_Value 16 5273_1_1 RD Compressor Loss of Differential Pressure Binary_Value 17 5275_1_1 RD Compressor Capacity Reduced Binary_Value 18 5513_1_1 RD Compressor Capacity Normal Binary_Value 19 5773_1_1 RD Compressor Contactor Issue Binary_Value 20 5774_1_1 RD Compressors - Compressor 2 Compressor Hours Exceeded Binary_Value 29 5269_1_2 RD Compressor High Head Pressure Binary_Value 30 5270_1_2 RD Compressor Low Suction Pressure Binary_Value 31 5271_1_2 RD Compressor Thermal Overload Binary_Value 32 5272_1_2 RD Compressor Low Oil Pressure Binary_Value 33 5273_1_2 RD Compressor Loss of Differential Pressure Binary_Value 34 5275_1_2 RD Compressor Capacity Reduced Binary_Value 35 5513_1_2 RD Compressor Capacity Normal Binary_Value 36 5773_1_2 RD Compressor Contactor Issue Binary_Value 37 5774_1_2 RD Active on Alarm Active on Alarm Active on Alarm Active on Alarm Active on Alarm Active on Alarm Active on Alarm Active on Alarm Active on Alarm Active on Alarm Active on Alarm Active on Alarm Active on Alarm Active on Alarm Active on Alarm Active on Alarm Active on Alarm Active on Alarm Active on Alarm Active on Alarm Extra Notes 1, 2 2 1, 2 1, 2 1, 2 1, 2 1, 2 1, 2 1, 2 2 2 1, 2 1, 2 1, 2 1, 2 1, 2 1, 2 1, 2 2 2
Page 1:
Infrastructure Management & Monitor
Page 4 and 5:
3.0 MODBUS 485 AND MODBUS IP PROTOC
Page 6 and 7:
3.4 Battery Monitoring Products . .
Page 8 and 9:
MODBUS 485 & MODBUS IP PROTOCOLS (c
Page 10 and 11:
2.3.2 Function Code 4 Modbus Commun
Page 12 and 13:
3.0 MODBUS 485 AND MODBUS IP PROTOC
Page 14 and 15:
Modbus 485 and Modbus IP Protocols
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Shutdown - Loss Of Power - Event Ty
Page 24 and 25:
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Remote Sensor System Average Over T
Page 38 and 39:
Page 40 and 41:
Table 10 Liebert CRV - Input and Ho
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Table 11 Liebert CRV - Glossary (co
Page 48 and 49:
Table 11 Liebert CRV - Glossary (co
Page 50 and 51:
Table 12 Liebert HPC (Chiller) - S
Page 52 and 53:
Table 13 Liebert HPC (Chiller) - In
Page 54 and 55:
Table 13 Liebert HPC (Chiller) - In
Page 56 and 57:
Table 14 Liebert HPC (Chiller) - Gl
Page 58 and 59:
Table 14 Liebert HPC (Chiller) - Gl
Page 60 and 61:
Table 15 Liebert XDC - Status and
Page 62 and 63:
Table 16 Liebert XDC - Input and Ho
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Table 17 Liebert XDC - Glossary (co
Page 74 and 75:
Table 17 Liebert XDC - Glossary (co
Page 76 and 77:
Page 78 and 79:
Table 19 Liebert XDP - Input and Ho
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Table 20 Liebert XDP - Glossary (co
Page 94 and 95:
Table 20 Liebert XDP - Glossary (co
Page 96 and 97:
Table 22 Liebert XDWP (XDP-W) - Inp
Page 98 and 99:
Table 23 Liebert DS and Liebert Pe
Page 100 and 101:
Table 24 Liebert DS and Liebert PeX
Page 102 and 103:
Table 24 Liebert DS and Liebert PeX
Page 104 and 105:
Table 26 Liebert XDF - Input and Ho
Page 106 and 107:
Page 108 and 109:
Table 29 Liebert DataMate, Liebert
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Table 40 Liebert APM - Status and
Page 142 and 143:
Table 41 Liebert APM - Input and Ho
Page 144 and 145:
Table 42 Liebert APM - Glossary (co
Page 146 and 147:
140 Modbus 485 and Modbus IP Protoc
Page 148 and 149:
Table 44 Liebert GXT2 and Liebert G
Page 150 and 151:
Table 47 Liebert Nfinity ® - Statu
Page 152 and 153:
Table 49 Liebert NX - Status and C
Page 154 and 155:
Table 50 Liebert NX - Input and Hol
Page 156 and 157:
Table 51 Liebert NXL SA, SR, SN, M
Page 158 and 159:
Table 52 Liebert NXL SA, SR, SN, MM
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Table 57 Liebert PowerSure Interact
Page 184 and 185:
Table 59 Liebert Series 300 UPS - I
Page 186 and 187:
Table 61 Liebert Series 600 UPS - I
Page 188 and 189:
Table 63 Liebert Series 610 SCC UPS
Page 190 and 191: 184 Modbus 485 and Modbus IP Protoc
Page 192 and 193: Table 65 Liebert SICE 7200 - Input
Page 194 and 195: Table 66 Liebert NPower - Input an
Page 196 and 197: Table 67 Liebert BDSU - Status and
Page 198 and 199: Table 68 Liebert BDSU - Input and H
Page 200 and 201: 4.0 BACNET COMMUNICATIONS BACnet Co
Page 202 and 203: 4.1.3 Standard Object Types Support
Page 204 and 205: BACnet Communications - BACnet Prot
Page 206 and 207: 4.2 Precision Cooling Products 200
Page 208 and 209: 202 BACnet Communications - Precisi
Page 222 and 223: Ext Standby Glycol Pump On - Event
Page 228 and 229: Table 73 Liebert CRV - Binary Data
Page 230 and 231: Table 74 Liebert CRV - Analog Data
Page 232 and 233: Table 74 Liebert CRV - Analog Data
Page 234 and 235: Table 75 Liebert CRV - Multistate D
Page 236 and 237: Table 76 Liebert CRV - Glossary (co
Page 238 and 239: Table 76 Liebert CRV - Glossary (co
Page 242 and 243: Table 77 Liebert HPC - Binary Data
Page 244 and 245: Table 77 Liebert HPC - Binary Data
Page 246 and 247: Table 78 Liebert HPC - Analog Data
Page 248 and 249: Table 79 Liebert HPC - Multistate D
Page 250 and 251: Table 80 Liebert HPC - Glossary (co
Page 256 and 257: Table 82 Liebert XDP, Liebert XDWP
Page 272 and 273: Table 86 Liebert Mini-Mate2 8 Ton -
Page 274 and 275: Table 87 Liebert APM - Binary Data
Page 276 and 277: Table 88 Liebert APM - Analog Data
Page 278 and 279: Table 90 Liebert APM - Glossary Dat
Page 280: Ensuring The High Availability Of M
show all

Liebert® IntelliSlot® Modbus 485, Modbus IP and BACnet IP

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?