30.01.2013 Views

Datascope Passport - Mindray

Datascope Passport - Mindray

Datascope Passport - Mindray

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Introduction Warnings<br />

Warnings<br />

WARNING: Internal Electrical Shock Hazard - This unit does not contain<br />

any user-serviceable parts. Do not remove instrument<br />

covers. Refer Servicing to qualified personnel.<br />

WARNING: Trace Gas Hazard - When using the optional Gas Module, a<br />

health hazard exists when trace amounts of vaporized<br />

anesthetic agents are chronically inspired by operating<br />

room personnel. See Appendix A in NFPA 56A on Inhalation<br />

Anesthetics. During any procedure where such agents are<br />

employed, the Gas Module exhaust output should be<br />

connected to a medical gas-scavenging system.<br />

WARNING: Do not use this monitor during MRI (Magnetic Resonance<br />

Imaging) scanning. Induced current could potentially cause<br />

burns. Accuracy of measurements on this unit and the MRI<br />

unit may also be affected.<br />

WARNING: For continued protection against a fire hazard, replace all<br />

fuses with the specified type and rating. See the <strong>Passport</strong> 2<br />

Service Manual, P/N 0070-00-0513-01.<br />

WARNING: Do not clean the monitor while it is on and/or plugged in.<br />

WARNING: This unit uses a common isolation path for the ECG leads<br />

and the Invasive Pressure Channels. Ensure that conductive<br />

parts of the ECG electrodes do not contact other conductive<br />

parts including earth ground. Do not connect any nonisolated<br />

accessories to the <strong>Passport</strong> 2 or to the ECG or<br />

invasive pressure channel inputs when connected to a<br />

patient. Insure that the total chassis leakage currents of all<br />

connected units does not exceed 300µA. Use an IEC 601-1<br />

approved isolation / separation transformer if required. Do<br />

not simultaneously touch the patient and any piece of<br />

electrical equipment if any cover has been removed from<br />

the equipment.<br />

WARNING: The AC line cord and interface cables (ie non-patient cables)<br />

may utilize the same ground. Therefore, removal of the AC<br />

line cord does not necessarily isolate the <strong>Passport</strong> 2, if nonpatient<br />

interface cables are attached.<br />

WARNING: Observe extreme caution when a defibrillator is used on a<br />

patient. Do not touch any part of patient, table, or monitor<br />

when a defibrillator is in use.<br />

WARNING: Microstream ® waste material and CO 2 filter should be<br />

treated as biohazard material.<br />

WARNING: Do not incinerate battery, possible explosion may occur.<br />

WARNING: Do not put MPSO (Multiple Portable Socket Outlets ie.<br />

Multiple outlet extension cords) used with the <strong>Passport</strong> 2/<br />

<strong>Passport</strong> 2 LT or its accessories on the floor. Connect only<br />

<strong>Passport</strong> 2/<strong>Passport</strong> 2 LT accessories to the same MPSO as<br />

the <strong>Passport</strong> 2/<strong>Passport</strong> 2 LT. Do not overload the MPSO.<br />

viii 0070-10-0649-01 <strong>Passport</strong> 2®/<strong>Passport</strong> 2 LT Operating Instructions

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!