Datascope Passport - Mindray

Decontamination of Monitor User Maintenance
4.3 Decontamination of Monitor
WARNING: Perform the decontamination process with the unit powered
down and power cord removed.
Decontamination of a unit that has come in contact with a biological material can be
performed using LpH SE Germicidal detergent. Apply a small amount of detergent to a
disposable wipe (paper based) and wipe down the outside of the unit. Discard the wipe
appropriately. After waiting 10 minutes, use a clean dry wipe to dry the unit.
CAUTION: During the decontamination process, do not get the LpH SE
Germicidal detergent into any vent openings.
4.4 Care and Cleaning of SpO 2 Sensors
NOTE: Refer to the individual instruction sheets that are packaged
with each sensor.
Daily, check the sensors and cables for signs of damage. Replace as required.
The sensors should be cleaned before and after each patient’s use.
Wipe the patient contact area using a soft cloth with mild soap and water solution or
isopropyl alcohol. Hydrogen peroxide can be used to remove dried blood on all
accessible surfaces.
Let the sensor completely dry before using.
CAUTION: When cleaning SpO 2 sensors, do not use excessive amounts
of liquid. Wipe the sensor surface with a soft cloth,
dampened with the cleaning solution.
4.5 Sterilization and Cleaning of Reusable
Bladderless Cuffs
Clean cuffs with warm water and a mild detergent. Do not use a detergent containing hand
conditioners, softeners, or fragrances.
NIBP cuffs can be sterilized with gamma sterilization without effecting the repeated
performance of the cuff. Steam sterilization is not recommended. Use of a washing liquid
containing bleach is not recommended because chlorine will chemically break down the
urethane on the inside of the cuff.
Antimicrobial Definition
Mindray DS bladderless cuffs are treated with an antimicrobial coating. Antimicrobial
technology effectively controls a broad spectrum of bacteria, fungi, algae and yeasts on a
wide variety of treated substrates.
4 - 2 0070-10-0649-01 Passport 2®/Passport 2 LT Operating Instructions