Datascope Passport - Mindray

Operation SpO 2 Pulse Oximetry
3.6 SpO 2 Pulse Oximetry
3.6.1 SpO 2 Menu
Masimo ® equipped unit
FIGURE 3-13 SpO 2 Menus
3.6.2 SpO 2 Measurements
1. Select the appropriate sensor for the patient.
2. Attach the SpO2 Patient Cable to the sensor and plug the other end of the patient cable
into the SpO2 connector located on the left side panel of the monitor.
NOTE: Do not place the sensor on an extremity with an IV catheter
or blood pressure cuff in place.
NOTE: Ensure proper routing of patient cable to avoid
entanglement and/or strangulation.
Nellcor ® equipped unit
CAUTION: When equipped with Masimo ® SpO 2, use only Masimo
oxygen transducers including Masimo LNOP ® patient
dedicated adhesive sensors and Masimo PC Series Patient
Cable. Use of other oxygen transducers may cause
improper oximeter performance.
CAUTION: When equipped with Nellcor ® SpO 2, use only Nellcor
oxygen transducers including Nellcor Oxisensor ® and
OxiMax ® patient dedicated adhesive sensors. Use of other
oxygen transducers may cause improper oximeter
performance.
CAUTION: Tissue damage or inaccurate measurements may be caused
by incorrect SpO 2 sensor application or use, such as
wrapping it too tightly, applying supplemental tape, failing
to inspect the sensor site periodically, or failing to position it
appropriately. Carefully read the sensor directions for use,
the Passport 2/Passport 2 LT operating instructions, and all
precautionary information before use.
Passport 2 ® /Passport 2 LT Operating Instructions 0070-10-0649-01 3 - 27