Datascope Passport - Mindray

Performance Specifications Appendix
6.2.23 Transferring Monitor Default Settings
When installing several Passport 2/Passport 2 LT monitors and identical display
settings and alarm settings are desired on each, a “Transfer Card” (P/N 0996-00-0051-01)
can be used to copy the settings from monitor to monitor.
1. Insert the Transfer Card into the PCM2 slot on the right side of the source monitor.
2. Access the Functions menu, and select “Copy monitor defaults to card” from the menu. A
status message will report completion of the transfer.
3. Remove the card and insert it into the PCM2 slot of the receiving monitor.
4. Enter Installation Mode on the receiving monitor (Press and hold the DISCHARGE key
during power-up.), and select “Copy monitor defaults from card”. A status message will
report completion of the transfer.
5. Select “Save Current” and power-cycle the receiving monitor to enter normal monitoring
mode.
6.2.24 Installation and Use of “Extended Trend” feature
6.2.25 Display
This feature is added to the Passport 2/Passport 2 LT by inserting the “Extended
Trend” card (P/N 0996-00-0052-01) into slot PCM1 on the right side of the monitor. The
card is to be inserted before monitor power-up, and never removed during monitor
operation. In order to guard against accidental removal, the card slot is designed so that
a tool is required to eject the card after insertion.
The “Extended Trend” feature is automatically enabled when the unit is powered-up
following card insertion.
NOTE: The Extended trend card must be removed prior to using the
12-Lead ECG features.
Size: 10.4” (diagonal) active matrix TFT
Resolution: 640 x 480 pixels
Sweep Speeds: 3.125 mm/, 6.25 mm/s, 12.5 mm/s, 25
mm/s, 50 mm/s
6 - 28 0070-10-0649-01 Passport 2®/Passport 2 LT Operating Instructions